How to program remote key on 2002 Nissan Sentra ?

Answer 1

1. Close and lock all doors with the driver’s side power lock/unlock switch.

2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. ( Withdraw key completely from ignition cylinder each time ) . If this procedure is performed too fast, system will not enter programming mode.

3. Insert key into the ignition cylinder and turn to the ACC position.

4. Within 5 seconds, push ANY button on the keyless remote. Your Hazard Lamps should flash. ( Do not press the button more than one time in the above step). If the button is pressed more than one time, the programming procedure will not be successful.

5. If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each keyless remote (including any existing keyless remotes).

6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.

Answer 2

I should cut and paste this here we go again.
#1. get into the car "roll down the window just for air". #2. lock the door with the power lock switch. #3. insert and withdraw the key completely six times in ten seconds. Plenty of time do not rush. #4. watch for the trun-signal arrows to flash twice. #5. put key back in and turn lock to on posistion, just before crank. #5 push any button on the first remote keyless fob turnsignals will flash twice. #6. any additional fobs? unlock and relock the door and push any button on the second remote turnsignals will flash twice. UP to 5 remotes can be programed unlock and lock between each, but each time you do above you have to have all of the remotes as this cancels all but the reprogramed keyless entry fobs.

Answer 3

i'm a Nissan grasp tech. the genuine deal... get into the truck use the lock turn on the door lock the truck. Push the substantial into the ignition lock and out of the lock 6 circumstances in ten seconds. The turnsignal alerts will flash two times turn the ingnition to acc. the posistion the place the warning lights fixtures illuminate around the speedometer activate, Then push any button on the distant and turnsignal alerts will flash two times 2d distant launch and relock the door with the swap push any button on the 2d distant you have got as many as 5 remotes. yet you need to application all of the remotes you % to apply on an identical time...

Answer 4

Your best bet would be to go to a dealership.

Answer 5

LOOK IN THE OWNER'S MANUAL