My truck is a Camper Special. I've tried to use a blanket as a seat cover before but it always slides down. I want it to look nice and tight but the seat doesn't fold forward so it's hard to tuck the edges of the blanket in. Should I remove the seat to do this, and if so, how?
2006-10-30 21:05:48 · 5 answers · asked by Qando 2 in Cars & Transportation ➔ Car Makes ➔ Ford
go to pep boys pick out the cover you like remove the seat and follow the directions and you must use hog rings to anchor it they come with it but you may need to buy the hog ring pliers tho they are inexpensive, the hog rings look like a nose piercing ring and they attach to the under wires of the old seat and it will anchor them very securely this is what the factory used when they built the full size ranger
2006-10-31 01:00:20 · answer #1 · answered by Mechanical 6 · 0⤊ 0⤋
ok, i had the same problem for my f-250, what i did was start at the top and work my way down, take a staple gun ( or anything similar if you cant get a staple gun) and just make sure you go horizontaly on the top, then in the middle fold, then again under the bottom. dont try it on a thick or knitted blanket though, .... lol trust me its harder that way....
2006-10-31 07:06:05 · answer #2 · answered by John S 1 · 0⤊ 0⤋
safety pins or if your seat cover has strings tie the ever loving heck out of them
2006-10-31 01:05:22 · answer #3 · answered by gremlinboi55 2 · 0⤊ 0⤋
Door springs under the seat. They don't stretch as much as bungee cords.
2006-10-31 00:30:22 · answer #4 · answered by R1volta 6 · 0⤊ 1⤋
Bungie chords! Man, don't you people know ANYTHING!
2006-10-30 21:06:50 · answer #5 · answered by cadee884 2 · 0⤊ 1⤋