Need exact location of crank positioning sensor for 2003 altima 2.5 s?

Question

Replaced idle sensor and car is still idling high in park position. Sometimes doing a sea saw thing.

Answer 1

Back side of the engine. remove the plastic engine top cover place a drop light behind the motor from on top where the heater hoses are between the engine and transmission split. Now the area is lit up remove the air filter to throttle boot and leaning over the motor look straight down between the throttle chamber and valve cover to the ground at the back if the motor one gold colored 10mm bolt black plug two wires and crank sensor. The connector is tricky to release push in the green thing all the way index finger and with your two little fingers pull gently on the wires and when your done the green connector part should pop back out if not the connector might not be locked in. I wash wd-40 and compressed air blow out the connector so it will snap on right. YOU KNOW ALL IF THIS MIGHT BE WARRANTY. Check with your nissan dealer.