The manual just says to take to a dealer, but I don't want to pay for a bulb change.
2006-10-25 07:19:40 · 5 answers · asked by Jack R 1 in Cars & Transportation ➔ Car Makes ➔ Audi
Rear Break Light
2006-10-25 07:37:57 · update #1
Do it yourself small access panel just inside your rear tail gate squeeze in the clips remove complete replace faulty bulb Regards Mick.
2006-10-25 07:44:39 · answer #1 · answered by mick 6 · 0⤊ 0⤋
Answered this b4.
Just inside the tailgate aperture there is a plug in the plastic trim about the size of a small coin.Lever this out with a small screwdriver.Behind the plug is a screw,remove this screw its about 2 inches long.
Now ease the lamp unit off the car,sideways (it may take a little 'working' as its held on clips) be careful not to chip the lens against the bodywork.
Now with the lamp unit off you can simply unclip the bulb holder and replace the bulb.
Reverse the procedure to refit.
5 min job.
Hope this helps.
2006-10-25 15:27:13 · answer #2 · answered by jixer 3 · 0⤊ 0⤋
Listen to Jixer!! Be careful not to damage the location pin on the light unit. It holds the tail light in position at it's outside edge. It's a small plastic pin with a "ball end" that fits into a plastic housing on 1/4 panel inner edge. If it breaks then tail light will rub against 1/4 & damage paintwork.
2006-10-25 18:44:38 · answer #3 · answered by carworker 1 · 0⤊ 0⤋
If it is a front headlight bulb you have to take the headlight out to access the bulb compartment
2006-10-25 15:33:29 · answer #4 · answered by Anonymous · 0⤊ 0⤋
what bulb headlight interior light need more info
2006-10-25 14:29:43 · answer #5 · answered by 808fl 5 · 0⤊ 0⤋