English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

we have replaced fuel pump assembly and gas tank external fuel pump oil pressure switch and still wont start will turn over and if youput fuel in the injectors it starts and stop immediaty the relay switch is set properly any suggestions thanks

2006-10-21 09:40:09 · 11 answers · asked by luanne d 1 in Cars & Transportation Car Makes Ford

11 answers

Maybe your fuel pressure regulator is bad..... When I am sick of troubleshooting I just take it to the local ford garage. It is usually cheaper than throwing parts at it.

2006-10-21 16:23:48 · answer #1 · answered by piplong2005 2 · 0 0

Yes, I'll bet you have tripped the fuel pump inertia switch, this is a
switch located on the inside of the cabin just above the front seat passengers feet on the firewall. It is designed to shut off the fuel pump in the event of a crash. However as these switches, which are spring loaded, get older, they sometimes trip on there own. Also if a passenger happened to bump the inertia switch with his foot, that could cause it to trip.

Just push the button on the top of the switch, back in, and start the vehicle....Good luck !

2006-10-21 09:46:20 · answer #2 · answered by Anonymous · 0 0

Look in the owner's manual for the 'fuel cut-off switch' or 'Inertia Switch'. It is designed to kill the fuel pump in an accident but sometimes a bad bump on the road will trip them.

2006-10-21 09:44:32 · answer #3 · answered by tumbleweed1954 6 · 0 0

Do you have fuel pressure? Sounds like the fuel pump, or fuel pump relay, check the small battery ground wires.
Another thought, it could be the processor.

2006-10-21 11:00:20 · answer #4 · answered by kayef57 5 · 0 0

put a boost on the battery and hold the peddle to the floor the entire time while you are turning it over. Don't take your foot off the gas until it is screaming .you did change the fuel filters too eh? Spark plugs? Check the air in the tires. Buy a CHEV.

2006-10-21 09:49:34 · answer #5 · answered by Jason 2 · 0 0

What was the situation before it refused to start ??
The parts store loves you diy people, change this change that money in the bank for them
There is a possibility you have air in the system from changing all those parts. I don't know the procedure on your vehicle to bleed system. injectors won't inject air on most systems.
check it out
CHILTONS manual is good investment for diy "mechanics"

2006-10-21 11:47:18 · answer #6 · answered by tronary 7 · 0 0

figure out the problem before u replace stuff eather u are not getting spark or fuel

2006-10-21 12:39:48 · answer #7 · answered by Anonymous · 0 0

are u getting power to the fuel pump??

2006-10-21 10:05:54 · answer #8 · answered by Anonymous · 0 0

i USED HAVE THAT PIECE OF JUNK,
THE PROBLEM ACCORDING TO MY WIFE IS NOT THE CAR, THE PROBLEM IS THE PERSONS WHO BOUGHT THIS PIECE UN SH.........................

I am agree with Found On Road Dead FORD

I GORGOT TO TELL YOU, later I bought a MAZDA B2300 is the same car FORD RANGER, en again th e problems started so..........................F:O:R:D:

Fix or Repair Daily FORD

2006-10-21 10:31:19 · answer #9 · answered by arqui 2 · 0 1

Found.On.Road.Dead

2006-10-21 09:42:39 · answer #10 · answered by oldslowchevy 3 · 0 1

fedest.com, questions and answers