I replaced the column shaft that cuts the blinkers on and off, got a new lighting control box, new fuse, and they're still not working. What could be going on?
2006-10-13 06:15:15 · 12 answers · asked by mariedadrien 1 in Cars & Transportation ➔ Car Makes ➔ Ford
I would first check the fuse for the blinkers..
2006-10-13 06:16:58 · answer #1 · answered by tyson 1 · 0⤊ 0⤋
Either the turn signal switch or turn signal relay. If the green light comes on when you put the lever in the turn position, check for burned out bulbs, front and rear. If the bulbs are OK, replace the flasher relay.
Master tech 40 yrs.
2006-10-13 07:24:50 · answer #2 · answered by Cal 5 · 0⤊ 0⤋
Could be the multifunction switch. Make sure the emergency flashers aren't on the on position
2006-10-13 11:44:14 · answer #3 · answered by kayef57 5 · 0⤊ 0⤋
check the flasher module, it should be in the same place as the fuses or close by.
If not, check out a CHILTONS manual at the library for your car.
Then if that doesn't work, trade for a different make of car.
2006-10-13 06:20:18 · answer #4 · answered by mygirls1374 2 · 0⤊ 0⤋
Check and see if brake lights are working, if they are then it is the flasher.
2006-10-13 06:26:35 · answer #5 · answered by smoke 4 · 0⤊ 0⤋
only if 1 bulb is burnt out that will cause it,or else its the flasher
2006-10-13 06:28:07 · answer #6 · answered by steve 5 · 0⤊ 0⤋
Be sure the hazard switch is down, work it and see if they start working. Seen this many times.
2006-10-13 15:53:35 · answer #7 · answered by Josh S 7 · 0⤊ 0⤋
did you change a flasher it located aruond or inside your fuse's box.
2006-10-13 06:19:00 · answer #8 · answered by pvphelp 2 · 0⤊ 0⤋
more than likely you need a cheap little flasher
2006-10-13 06:20:14 · answer #9 · answered by nbr660 6 · 0⤊ 0⤋
Did you check the flasher?
2006-10-13 06:17:12 · answer #10 · answered by hsueh010 7 · 0⤊ 0⤋