how to programme infinity g35 coupe 2005 keyless remote?

Question

I want to programme my keyless remote for my Infinity G35 coupe, how can I do that ?

Answer 1

1. Close and lock all doors with the driver’s side power lock/unlock switch.

2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. ( Withdraw key completely from ignition cylinder each time ) . If this procedure is performed too fast, system will not enter programming mode.

3. Insert key into the ignition cylinder and turn to the ACC position.

4. Within 5 seconds, push ANY button on the keyless remote. Your Hazard Lamps should flash. ( Do not press the button more than one time in the above step). If the button is pressed more than one time, the programming procedure will not be successful.

5. If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each keyless remote (including any existing keyless remotes).

6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.

Answer 2

do exactly this get in car put key in lock turn to on, roll down windows. That step is optional if it is snowing outside. With all doors and hood trunk closed, Sitting in the drivers seat use lock switch lock doors, insert withdraw ignition key from ignition lock 6 times in ten seconds plenty of time be precise. Turn signal will flash twice. Now reinsert key and turn to the on position just before crank Push any button on the first remote turn signals will blink. Second remote unlock and re lock the drivers door switch push any button on the second remote. If you mess up take key out unlock and open drivers door and start over.