replacement cost of front wheel bearing on 2002 mercury sable parts and labor
2006-09-28 20:33:28 · 10 answers · asked by kay p 1 in Cars & Transportation ➔ Maintenance & Repairs
At my shop it would be under $200
http://econofix.com
2006-09-28 20:39:33 · answer #1 · answered by econofix 4 · 0⤊ 0⤋
Cost can vary . If I was doing it , It would be just parts. A shop doing it would be Parts and Labor . The cost factor can be from one end of the scale to the other . It all depends on who is doing the job for you. Seek out someone you trust . A place where I use to take my cars was the Local High Schools and Colleges . They will do it for cost of parts . The catch is they have the learning students doing the work . But it is supervised and always double checked by the Shop Proctor before returning the car back to you .......Bearings usually run about 10.00 to 20.00 bucks Each. It comes with a Race and the Bearing . Inner and Outter Bearings should always be replaced as a set. Always be sure to get a reliable person . It can be very dangerous for a back yard mechanic to think he knows how to do it ..... Just tighting the nut on the assembly and putting a new carter pin in can sometimes
be not adjusted right ( Pressure wise ) or forget to put the pin back in . Causing the nut to come lose and having a wheel come off . I am almost sure every one has seen a front wheel be missing on the freeway only to see it a quarter mile down the way ...... Yep make sure you get someone who knows their stuff.
2006-09-28 20:46:29 · answer #2 · answered by marshoberg55 4 · 0⤊ 0⤋
2002 Mercury Sable Parts
2016-10-14 02:44:13 · answer #3 · answered by Anonymous · 0⤊ 0⤋
First jack the car up. You need to take the wheel off. There will be like a 30mm? nut on the half shaft. You have to remove that. You will probably have to remove brake parts (disc, etc...). Then there are like four torx bolts holding the bearing on. It is a sealed bearing. You just replace this with a new one. They used to cost around $125 when I replaced them ten years ago. I will have to say they rarely went bad. Of thousands of cars I worked on, I have only replaced a handful.
2016-03-26 22:21:15 · answer #4 · answered by Anonymous · 0⤊ 0⤋
Go to your local parts store or online and get a price for the bearing. probably no more than $10-$20 and 1 hour labor for an ameteur!
2006-10-02 11:39:21 · answer #5 · answered by Anonymous · 0⤊ 0⤋
it has an inner and outer parts 70 bucks .labor about the same not over 200 and no less than a 150 dollars.
2006-10-02 13:35:27 · answer #6 · answered by duc602 7 · 0⤊ 0⤋
Haven't thought about it
2016-08-08 16:06:04 · answer #7 · answered by ? 4 · 0⤊ 0⤋
About $100.00, you can go to Pep boys in your city.
2006-09-28 20:36:58 · answer #8 · answered by junaidi71 6 · 0⤊ 0⤋
I think it depends
2016-08-23 07:49:04 · answer #9 · answered by chanda 4 · 0⤊ 0⤋
I do not believe that to be accurate
2016-09-21 01:27:16 · answer #10 · answered by Anonymous · 0⤊ 0⤋