I have tried to fit this Kenwood KDC-W7031 stereo into my 1993 astra. It connects without any additional wires but does not keep the memory. I was advised to buy the correct harness but this did not fit, the end of the stereo has a connnection with 2 parts but the wires from the car have a connection that has 3 parts how can i ge this to fit??
2006-09-16 21:52:19 · 9 answers · asked by stephenpowell25@btinternet.com 1 in Cars & Transportation ➔ Car Audio
they have a 800 number will be glad to help you .
2006-09-16 21:55:30 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Kenwood Kdc-w7031
2016-12-13 06:04:01 · answer #2 · answered by ? 4 · 0⤊ 0⤋
This Site Might Help You.
RE:
Fitting Stereo. Kenwood KDC-W7031?
I have tried to fit this Kenwood KDC-W7031 stereo into my 1993 astra. It connects without any additional wires but does not keep the memory. I was advised to buy the correct harness but this did not fit, the end of the stereo has a connnection with 2 parts but the wires from the car have a...
2015-08-10 07:29:04 · answer #3 · answered by Lorinda 1 · 0⤊ 0⤋
The fitting coming out of the dash is a standard iso fitting used on all cars. Vauxhall have 3 parts: 2 smaller ones for the stereo and the third one is for the display in the dash. You can get a converter to fit the third so the diplay will display radio station or cd your listerning too - but very expensive. The display will still tell time and temperature, (if you have temp) although I`ve never bothered with that and I've always had vauxhall cars/vans.
Regards to memory, red is permanent live; yellow is ignition live.
2006-09-17 05:58:37 · answer #4 · answered by Anonymous · 1⤊ 0⤋
1 The red and yellow wires need to be swapped around ,the kenwood wired loom should have bullet connectors half way down the loom to do this.
2 The third plug is for the high level display , just put it to the back out of the way,all the display will show is time and date
good luck hope this helps
2006-09-17 12:01:42 · answer #5 · answered by loveb00ts 2 · 0⤊ 0⤋
Sound like you got the memory power and constant power wires mixed up. If you have a red and yellow wire, they should probably be switched. The yellow wire is for the memory and should be hooked up to a constant source from the battery (always on). The red wire should only have power when the key is on.
2006-09-16 22:52:30 · answer #6 · answered by Powder 2 · 0⤊ 0⤋
Check the wiring diagram with the set and it will advise you.
That is if it is a new one, otherwise take it to a car radio installer
2006-09-16 21:56:32 · answer #7 · answered by Boscombe 4 · 0⤊ 0⤋
Switch the yellow and red wires around that should do the trick
2006-09-17 09:43:12 · answer #8 · answered by Anonymous · 0⤊ 0⤋
I agree with g w go to crutchfield
2006-09-17 04:06:45 · answer #9 · answered by C live 5 · 0⤊ 0⤋