The aim of this is to wind the line onto your reel in the opposite direction to which it was wound onto the spool in order to eliminate the twists in it. Wind it on the wrong way and you will increase the amount of twists.
Hold the edge of the spool of line on one side and watch how the line falls off. It should become apparent by the coils/twists.
It's easier if the reel is attached to a rod and you have a friend to hold the spool and put some tension in the line.
If you find that you have excessive line twist, clip on a weight and cast across a field, lay the rod down and walk over and unclip the weight, now reel in. The line should untwist by itself.
2006-09-14 03:40:06
·
answer #1
·
answered by Anonymous
·
0⤊
0⤋
examine the line weight printed on the reel. The reel might want to have on it something like 10/one hundred and fifty 15/one hundred or something to that effect. It capacity the reel will carry one hundred and fifty yards of 10 pound try, one hundred yards of 15 pound try, and so on. As some one stated above, 10 pound try is a sturdy all-objective line weight for freshwater. To load the reel, open the bail first, then tie the line onto the spool. close the bail and turn the reel take care of to wind the line on. With a spinning reel it really is impressive to set the spool of line on the floor with the label dealing with up. turn the reel take care of 10 or 20 circumstances then provide as a lot as see if the line is twisting. even if it really is, turn the spool of line over and save winding it. provide up each and every so oftentimes to make positive the line isn't twisting.
2016-11-26 22:50:16
·
answer #2
·
answered by gandarilla 4
·
0⤊
0⤋
Yes ! It has to be done so line twist is avoided. This is accomplished by reeling the line on from the opposite direction it was feed onto the spool the line came on. Check often to make sure the line is not twisting, if it is flip the line spool over in the opposite direction of the twist.
2006-09-14 11:36:29
·
answer #3
·
answered by ? 5
·
0⤊
0⤋
The proper way is for the spool of new line to be held at right angles to the rod as it is loaded on so that the line comes off it the same way as it will come off the reel spool.
2006-09-14 02:21:11
·
answer #4
·
answered by Jellicoe 4
·
1⤊
1⤋
If you want to do the job properly.
Take your rod and reel to a field.
Have someone walk away from the prethreaded rod until all the line is out.
Wind in slowly with one hand controlling feed to spool pressure.
2006-09-14 02:34:55
·
answer #5
·
answered by Anonymous
·
0⤊
0⤋
jellicoe is spot on but keep your line tight when loading.
2006-09-15 20:59:19
·
answer #6
·
answered by nikgy71 5
·
0⤊
0⤋
there is most certainly a right way, ask at your local bait shop, they should be able to show you.
2006-09-14 02:19:33
·
answer #7
·
answered by Anonymous
·
0⤊
0⤋
yes !!!!!!!!!!!!!!!
2006-09-14 03:02:09
·
answer #8
·
answered by john l 5
·
0⤊
0⤋
yes..............
2006-09-14 02:19:26
·
answer #9
·
answered by Happy. 3
·
0⤊
0⤋