How do I "hard resent" my Tunsten e2 palmtop?

Question

How would i do a hard reset on my Tungsten E2?

Answer 1

start with mild resent?

just kidding.



maybe the back of the manual, otherwise you might have to call abroad (a.k.a. customer service)

Answer 2

Doing a hard reset on your Tungsten E2.
http://www.palm.com/us/support/handbooks/tungstene2/en/maintain.pdf#search=%22%22hard%20reset%22%20%22Tungsten%20E2%22%22

Only do a hard reset if a soft reset doesn’t solve your problem, or if you want to clear all of your information from your handheld.

A hard reset deletes all records and entries stored on your handheld, including the username that identifies the handheld.

This is another reason why it's important to synchronize often,
so you have an up-to-date backup available. Before you do a hard reset, be sure to synchronize.

1 - Press and hold the power button.

2 - While holding the power button, use the tip of the stylus (or a similar object without a sharp tip) to gently press and release the reset button inside the hole on the back of your handheld.

3 - Wait for the Palm Powered™ logo to appear, and then release the power button.

4 - When you see the message that warns you about erasing all of the info on your handheld, do one of the following:

• Press Up on the 5-way navigator to finish the reset and show the touchscreen.

• Press any other button to do a soft reset.

Done

.

Answer 3

Push reset pin with holding up arrow (or power button I forgot) at the same time. You will be prompt when the screen turns back on.

E2 is not non-volatile so this should apply, or drain the battery would do the same trick of hard reset, too.