hi there , on the back of the control nearest the motor you have a key and a choke button, on top you have a cold start lever, go to the gas tank and pump the gas ball till hard,next lift the cold start lever, useing the thumb of your left hand hold in the choke button, with your right turn the key to the start possition, hold in choke till motor kicks, let off choke ,turn key engine should be runnig now but in high idel , as it smooths out lower the cold start lever till engine is running smooth.....on the side closest to you ,you have a' t ' handle lever, push it forward out of center and your boat will go forward ,,pull to the rear and your boat backs up .the center divit is neutral, handle must be in neutral to start...happy boating
2006-08-21 13:09:35
·
answer #1
·
answered by burnie_1_2000 4
·
0⤊
0⤋
A mercontrol single lever control unit is one of the most complex in the industry. It is made of durable material, custom wireing, and of course, most importantly, the rigid metalic lever. To activate the unit turn it on with the integrated toggle switch, and move the lever to the right, or was it to the left, I think it was the right. Caution: the unit may overheat after just one hour of operation. To remedy the situation submerge the entire contraption in water, or hydrocloric acid (which ever is easiest to obtain). If hydrocloric acid is used be careful not to get any on your skin. After submersion the unit will work like a dream.
2006-08-21 13:14:31
·
answer #2
·
answered by skatefast2003 2
·
0⤊
0⤋