ive just fitted in my samsung SH-S162L dvd burner . ive upgraded the firmware from a disc but still it is not installed. wat drivers or things do i need to do so i can start using it ?
2006-08-14 03:35:54 · 8 answers · asked by jahangirjt 1 in Computers & Internet ➔ Hardware ➔ Add-ons
Nero heats up your summer with a limited time MP3 Power Pack special
so you can convert unlimited amounts of your favorite songs to MP3 or mp3PRO to enjoy on those endless summer nights. So make your season sizzle with this hot Nero deal!
http://www.nero.com/eng/index.html
2006-08-14 03:41:11 · answer #1 · answered by love peace 4 · 0⤊ 0⤋
Its person-friendly actually, its a plug and play device. once you've a CD Rom put in then its damn person-friendly. merely disconnect the ROM and replace it with the DVD Burner or author with the same type of connections (they're same). you'll get your device up and operating. Else keep on with this, Open CPU'S left hand area. you'll see lot of wires. Out of those one will seem as if white joint cables that are broader in structure. those are records cables. provide one connection to the DVD Burner (the position you'll lot of spikes, the cable were given holes for it) and there are power cable coming by skill of your SMPS. typically Yellow and pink colored wires at the same time. Get one connection of this to the DVD Burner. placed pink wire on the interior area, so this may more effective wholesome actual. now you're executed. Restart the computer and be conscious in case your pc has detected the device or no longer? If no longer verify back the connections. looks not person-friendly. yet its no longer. provide it a try. each and each of the suited
2016-11-25 00:27:11 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Did you connect all the cables to it, including the power source. It should light up when you turn your computer on. Otherwise, there's a very small wire that goes from the burner to the motherboard. It has 4 pins. Read the instructions to install the small wire.
2006-08-14 03:40:14 · answer #3 · answered by !{¤©¤}! 4 · 0⤊ 0⤋
Put the DVD-Burner into one of the CD-Slot/Bay. Use the IDE cable connect to the back of your DVD-Burner, and also connect the power cable to your back of your DVD-Burner. Once you done that, then you should able to use it. There no more require software or installation.
2006-08-14 03:39:41 · answer #4 · answered by Anonymous · 0⤊ 0⤋
Ckeack samsungs site for drivers, and upgrading firmwaire is the last think u should du...
2006-08-14 03:41:01 · answer #5 · answered by B1t Hunt3r 5 · 0⤊ 0⤋
Look at the back for the jumper settings. You will se (M) Master, (s) slave and (cs) cable select. set your new drive jumpers to the same setting as the old drive or CD drive that you have replaced.
2006-08-14 03:43:49 · answer #6 · answered by Anonymous · 1⤊ 0⤋
if your running two things on the same ide cable one needs to be master and the other slave
2006-08-14 03:39:45 · answer #7 · answered by Anonymous · 0⤊ 0⤋
try reading the instruction
2006-08-14 03:41:55 · answer #8 · answered by Anonymous · 0⤊ 0⤋