English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

I never really understand why when you get a beautiful arrangement of long stem roses, after about a day in a vase with water they start to bend at the neck or seem like they are about to die. It totally sucks!(urgh) Does it mean they were at their end when they were purchased, they were a bad batch to begin with or some other reason? I would really like to know in order to avoid this from happening in the future. Anyone who knows about roses?

2006-08-02 17:39:48 · 12 answers · asked by lady_lilacs 2 in Science & Mathematics Botany

12 answers

A rose bud/flower on the plant receives a continuous water supply from the soil through its stem/stalk.

When it is cut; its life line is cut and the process of withering is set in.

To prevent this and to keep them looking fresh in a flower vase for a longer time kindly try the following.

1) Get fresh roses with long stalk from a reputed supplier.
2) At home, cut the lower end of each stalk obliquely for an inch or so UNDER WATER.
This will get rid of air bubbles that have entered the xylem elements in the stalk.
They are the water carriers in the upward direction.The air bubbles block the passage of water.
Cutting the lower ends under water prevents fresh air bubbles entering the xylem elements.
3) Transfer these roses to the flower vase containing enough water immediately; so that the lower cut portion remains under water continuously and the water supply to the flower/bud is unhindered.
4) Protect the flowers from strong wind and high temp. as both these factors increase the loss of water from the flowers.

2006-08-02 18:03:26 · answer #1 · answered by Anonymous · 10 0

1

2017-01-22 06:21:29 · answer #2 · answered by Larry 3 · 0 0

Stem stiffness is the result of stem cell pressure, which is the result of osmosis, the movement of water into and through the plant from the ground up. The water in a plant also contains nutrients.

The water in the vase has no nutrients. This causes the osmotic pressure to be higher in the stem than in the water, so water can not be taken into the stem.

There are powders - probably sugar or the like, but all quite secret in formula - which can be added to the vase water to raise its osmotic pressure so that the water can flow into the stems. Be sure to trim off the dead end of the stems first before putting them in the water.

If you like to have cut flowers and want them to last a long time, do some experimenting on your own. Get several vases and put varying amounts of carefully measured powders in them and see which promote long life in the flowers. Try these:
1. Sugar - varying amounts.
2. Lemon juice - varying amounts
3. Clorox - just a bit! Be careful! You just want to kill the algae and bacteria, not the flowers!
4. Honey?
5. Milk! ?? Give it a try. Probably turn the water milky and sour! hahaha
6. What else could work?

;-D When you find the perfect answer, patent it and make a lot of money! That is what happened to the lady who invented white-out liquid from household ingredients!

2006-08-02 17:54:23 · answer #3 · answered by China Jon 6 · 1 0

To make roses last as long as possible, follow these guidelines.
Steps:
1. Store the roses in a cool place - ideally a refrigerator - if you can't get them into water immediately. A cool environment will help to slow the deterioration process.

2. Fill a vase with warm or tepid water. Make sure it's no cooler than room temperature. Warm water will be absorbed more quickly.

3. Add floral preservatives to the water if you have some available. Follow the package instructions.

4. Cut off any foliage that will lie below the waterline (it will rot), as well as any torn leaves.

5. Cut off about 1 inch of the stems, either straight across or at a slant, using a knife rather than scissors. Do this while the stem is submerged in a basin of warm or tepid water.

6. Place the roses in water immediately after cutting them.

7. Change the water and recut the stems daily, taking extra care to remove any leaves that may have wilted or dipped into the water. This will help prevent bacteria buildup. If you're using preservatives, add more solution every other day.

8. Keep the flowers in a cool, dry place, away from direct sunlight, heaters, air conditioners and drafts. At night, move your roses to the coolest part of the house. This will help them last longer.

Tips:
There are many other factors that go into the duration of a cut rose, including rose type, gardening methods and climate; however, following these steps will allow you to keep your roses fresh for as long as possible.

You can make your own floral preservative using a citrus-based soft drink. Add one part soft drink for every three parts water.

Put one aspirin in the vase and it would help keep the roses alive.

In the restaurant business, they add a few drops of bleach to the vase water. It keeps the water clear and the flowers fresh.

2006-08-02 17:53:13 · answer #4 · answered by elcycer 3 · 1 0

It can happen for a couple reasons.
First - depending on the florists' stock and how long they have been on hand...
they weren't wired correctly....if you notice roses are usually de-thorned by the florist and a wire is wrapped around the stem to give support to the flower.....
It may be too hot where you have them displayed....or too cold for that matter!
the water used may not be the freshest - you will usually get a little packet of powder from the florist with the arrangement - USE IT! After a day or two change the water and cut about an inch off the end of each flower - sounds like a pain but can extend the life of your bouquet.

2006-08-02 17:49:21 · answer #5 · answered by angdarling1 4 · 0 0

Try using lukewarm water and cutting the stems at a 45 degree angle, and they should last longer. If they are bending after just 24 hrs then they were not getting water. Perhaps either you or the business you purchased them from left them out of the water for too long and they scabbed over, not allowing water to get through.

2006-08-02 17:46:09 · answer #6 · answered by niceguy8991 1 · 0 0

Roses need water and nutrition.They get it through the stem. If the stem is cut off and then not immediately put in water - air will block the way so that even if you put your roses in water after a while - they will not be able to "drink". Make sure you cut them JUST before you put them in water. And make sure the water is HOT. You need to add nutrition to the water if you want the roses to live longer. The florist usually sends some little bags with the flowers. if your roses are already droopy, just cut the stems again and put them back in the water. You might be able to save them.

Hope it helps!

2006-08-02 17:50:46 · answer #7 · answered by the Engineer 2 · 0 1

Disolve an aspirin in a 1/2 gallon of water; add a 1/4 teaspoon of sugar; shake it to make sure everything is disolved. Add it to the water you already have in the rose to make it last longer. Another hint: let the tap water sit overnight to release any chlorine in the water - chlorine is acidic and will shorten the life of the rose.

2016-03-16 12:52:00 · answer #8 · answered by Anonymous · 0 0

that is because when kept in a vese , it does not get enough water as it should. so due to the difference in the concentration of water inside and outside the cells of the rose twig(there is more water inside the cells than outside) ex-osmosis takes place, that is water moves out of the cells and plasmolysis takes place, i.e the cell material withdraws from the celll wall and it does not remain taut anymore. so the plant wilts.
to stop it try to add some salt and some sugar to the water in the vase u keep it in.

2006-08-03 00:40:01 · answer #9 · answered by shaleen c 2 · 0 0

Want you like to get instant access to over 16,000 woodworking plans?
Check it out https://tr.im/4f401
Along with stone, mud and animal parts, wood was one of the first materials worked by early humans. Microwear analysis of the Mousterian stone tools used by the Neanderthals show that many were used to work wood. The development of civilization was closely tied to the development of increasingly greater degrees of skill in working these materials.

2015-01-24 08:45:44 · answer #10 · answered by Anonymous · 0 0

fedest.com, questions and answers