a steamer works, but i think they r a pain in the a**
the wall paper store has a tool with small rollers that have lots of sharp points these will cost about $5.00. run it all over the paper the take a big brush and hot water paint the paper with a good amount of water. what i found to work best is get a peice of painters plastic drop cloth u can get one at wal-mart for a few dallors.
after u wet the paper hang the plastic and use thumb tacks at the top let it drap down and stick to the wet wall. leave it for ohhhh about 20min then check a small part to see if ready.
i like this it is cheap and easy.
good luck
and yes fabric softener does help.
2006-07-31 23:04:20
·
answer #1
·
answered by Anonymous
·
5⤊
0⤋
Borrow a carpet steamer or a wall paper steamer or get an previous iron and steam the wall extremely at a time, the longer you carry the steam on the wall the more straightforward it receives, even if it merely takes some seconds, then once you get the scraper lower than it, it merely falls off. also for information on portray, obviously it relies upon on the outdoors. when you're going over a tremendous floor a huge roller is fastest, yet when you're portray over anigliptor or blown vynal as adversarial to a flat floor you're better with a broom and between the little rollers you could purchase. For portray the celing I strongly recommend you take advantage of a diverse coloration or coloration replacing paint (b&q have one which is going on red and dries white) or you get white blindness and finally end up with a patchy celing. also attempt to apply a small roller, you receives better insurance and make a lot less mess and finally when you're up a ladder to paint the celing, have someone on the floor to allow you to recognize the position you've ignored coz they are going to be able to see alot better. wish this helps.
2016-11-27 05:30:41
·
answer #2
·
answered by peirson 4
·
0⤊
0⤋
Use a product called DIF. It is a wallpaper stripper spray gel. It is easy to use and inexpensive. I have used it on all my wallpaper removal. It will take the old up and not hurt your plaster. Good Luck
2006-08-01 01:31:00
·
answer #3
·
answered by mom of 4 1
·
0⤊
0⤋
score the walls with a stanley knife blade(in a grid fashion) then steam the walls, scoring the walls helps to penetrate behind the paper. if you do not have a steamer then use hot water with washing up liquid, the washing up liquid thickens the consitency of the water making it stay on the walls a bit more instead of just running straight off. i would recccomend a steamer though, theyre very cheap these days(some are less than 20 quid!)
2006-08-01 08:11:25
·
answer #4
·
answered by ogden25uk 3
·
0⤊
0⤋
Never tried steaming. I've done the stuff that works by enzymes eating the adhesive. You score the wall with a palm-held roller, paint on the enzyme stuff, wait a little, and scrape. Comes off very easily. Good luck, it's not the nicest job in the world.
2006-07-31 20:41:46
·
answer #5
·
answered by Anonymous
·
0⤊
0⤋
Yes a steamer would do it most of the time ..if the paper you are removing is venial its not so easy ..you will need to scrape the surface of the paper before the steam penetrates Through..good luck..lol
2006-07-31 20:53:37
·
answer #6
·
answered by JJ 7
·
0⤊
0⤋
Hire or borrow a wallpaper steamer, you place it on the stuck paper and it applies steam and usually comes off quite easy.
2006-07-31 20:40:16
·
answer #7
·
answered by Anonymous
·
0⤊
0⤋
Yeah a steamer is best also cut criss crosses into the paper first with a sharp blade this helps the steam penertrate the paper and glue.
Lovely job
2006-07-31 20:42:27
·
answer #8
·
answered by Anonymous
·
0⤊
0⤋
steamers are good but if you don't have one watered down wallpaper paste works good just paste it on a bit at a time let it soak in a bit and the old paper pulls of dead easy you don't even need a scraper.
2006-08-01 16:17:22
·
answer #9
·
answered by keny 6
·
0⤊
0⤋
you can rent a steamer from your local hardware store. If the wallpaper was applied directly over wallboard you have problems though. Be very careful that you are not removing parts of the wallboard or you will have a real problem.
2006-07-31 23:48:04
·
answer #10
·
answered by mandp 4
·
0⤊
0⤋