What choke tube is best for trap shooting?

Answer 1

Choosing The Right Choke For Your Shotgun
Loads and hunting conditions factor into the equation

The evolution of the shotgun from flintlock to modern repeater capable of firing fixed ammunition is important, as are other inventions such as smokeless powder, nonmercuric primers and plastic hulls, but all combined do not hold a candle to the importance of choke development. If not for choked barrels, shotguns built today would perform about the same as those built during the 1800s and earlier.

We may never know for certain who discovered that the range of a shotgun could be increased by reducing or "choking" its bore to a smaller diameter at the muzzle, but in the United States an Illinois duck hunter named Fred Kimble is usually given credit for coming up with the idea around 1866. Through the decades most guns had fixed chokes and while the introduction of aftermarket devices such as the Cutts Compensator with its screw-in choke tubes of various constrictions became popular with skeet shooters during the 1950s, few hunters used them.

Evolution of the interchangeable choke system took another leap forward in 1959 when Winchester introduced its glass-barreled Model 59 shotgun with the Versalite choke system but several more decades would come and go before the idea became universally accepted by hunters. The eventual adoption of the interchangeable choke system by shotgun manufacturers increased the versatility of the old scattergun by leaps and bounds and it saved shotgunners a lot of money as well. No longer is it necessary to buy extra barrels in order to have different choices in chokes; today's guns come with a variety of screw-in chokes that can be switched with a twist of the wrist.

The amount of choke in a barrel is easily determined by subtracting the inside diameter of the choked area from the diameter of the bore, both measured with special gauges available from Brownells. If, for example, the bore of a 12-gauge barrel measures .729 inches and its choke measures .694 inches, it has .035 inches of constriction, which is rated as Full choke. The bores of 12-gauge guns can vary anywhere from .720 to .740 inches among various manufacturers but regardless of what the bore actually measures, the barrel is choked Full if its choke diameter is .035 inches smaller than the bore.

Chart No. 2 shows the amount of constriction assigned to various degrees of choke by Briley manufacturing, the largest manufacturer of screw-in chokes in the country. Choke for choke, constrictions are the same for the 10, 12, 16 and 20 gauges but differ for the 28 and .410 once we get tighter than Improved Skeet. This is done in order to keep the constriction percentages close to the same. For example, if we squeeze down a 12-gauge, .729-inch bore by .035-inch, we are reducing its diameter by about five percent. If we reduce the .550-inch bore of a 28-gauge barrel by that same percentage, we arrive at a choke constriction of .026 inches, which actually falls between what Briley indicates as Full and Extra Full chokes for that gauge.

Every shotgunner should understand how to determine the amount of choke in a shotgun barrel but actually doing so is not an absolute necessity. Even with that knowledge, the only way to know for certain how a gun and load combination will perform downrange is to pattern-test it on paper. Anybody can do it; simply shoot a sheet of paper measuring around 40 inches square at 40 yards, draw a 30-inch circle around the highest concentration of pellet holes in the paper and then count the holes. If, for example, the ammo you are shooting is loaded with 11⁄4 ounces of No. 2 steel shot, it contains approximately 156 pellets (see Chart No. 3).

Chart 1
Percentage Of Shot Inside 30" Circle
CHOKE 20 Yds 30 Yds 40 yds
Cylinder 80% 60% 40%
Skeet 92% 72% 50%
Improved Cylinder 100% 77% 55%
Modified 100% 83% 60%
Improved Modified 100% 91% 65%
Full 100% 100% 70%

If you count 94 pellet holes, your gun placed 61 percent of the shot charge inside the 30-inch circle. Referring to chart No. 1 reveals that the load is delivering Modified performance. To get a better picture of how the gun is performing, shoot at least five patterns with the same load and take the average of the results.

Keep in mind that just because your gun delivers Modified (or whatever) performance with one load doesn't necessarily mean it will do the same with other loads. Also keep in mind that just because the barrel of a gun or its screw-in choke was marked "Modified" or "Improved Cylinder" at the factory does not mean it will deliver Modified or Improved Cylinder choke performance with all loads.

Different loads from various manufacturers or even different loads from the same manufacturer can vary in a number of ways and those variations can result in a difference in performance even though choke constriction remains the same. Even though the load you just tested delivered Modified performance, another load might deliver Improved Cylinder performance while the next might perform as if your gun is choked either tighter or looser.

Chart 2
Standard Choke Constrictions in Inches
(From Briley
Choke Gauge
DESIGNATION 10/12/16/20 20/410
Cylinder .000" .000"
Light Skeet .003" .003"
Skeet .005" .005"
Improved Skeet .007" .007"
Improved Cylinder .010" .009"
Light Modified .015" .012"
Modified .020" .015"
Improved Modified .025" .018"
Light Full .030" .021"
Full .035" .024"
Extra Full .040" .027"
Super Full .050" -------

The same rule also applies to different guns. If you test two seemingly identical shotguns with exactly the same amount of choke constriction in their barrels, one might deliver Improved Cylinder choke performance with Load A while the other gun delivers Modified performance with the same load. Like I said before, the only way you will know for certain how a particular gun and load combination is performing is to spend some time with both at the pattern board.

One of the great things about screw-in chokes is they give us the option of conveniently and inexpensively trying different constrictions with different loads. If you hunt flooded timber where most shots are taken inside 20 yards, you need the largest pattern your gun will shoot while maintaining adequate pellet density. If that box of shells you recently bought is delivering overly tight patterns for those conditions, just screw out the Modified or Improved Cylinder choke and screw in a Skeet or Cylinder choke.

Moving to the opposite extreme, if the box of ammo you have is not delivering a dense enough pattern at 30 yards for consistent multiple pellet strikes on mallards, simply replace the Modified choke with Full or perhaps even Extra Full. But be careful when using extremely tight chokes as once the optimum amount of choke is reached for a particular load, a further increase in constriction can actually have a negative effect on pattern quality.

Chart 3
Number Of Pellets Per Ounce
SHOT SIZE LEAD* STEEL
8 585 - - -
7 1/2 410 - - -
6 225 316
5 170 243
4 135 191
2 87 125
1 - - - 103
BB 50 72
BBB - - - 61
T - - - 52
F - - - 40
*Pellet counts for bismuth and Tungsten-Matrix shot are about the same for lead

Choosing chokes for specific hunting conditions is quite important. For shooting where most birds are taken inside 25 yards, Skeet and Improved Cylinder are our most useful chokes. When teamed up with the right load, those two deliver adequate pattern density for shots out to 25 long paces and yet pattern diameter is large enough to make hitting birds that flash by just off the muzzle of your gun quite easy.



For most of the waterfowling I do Improved Cylinder is the most useful although Modified comes in a very close second. While less useful for all-around use than more open chokes, there are times when Improved Modified is a good choice. As a rule, and depending on the load used, Improved Modified will extend range by five to 10 yards over Modified with some loads and yet at closer ranges it is easier to hit with than Full choke. When hunting with a side-by-side or over-under double, I often use Improved Cylinder in one barrel and Improved Modified in the other. About the only time I ever use chokes tighter than Improved Modified is when pass-shooting at longer ranges.



Those rules work for most of my guns and me but only pattern testing will determine if they work equally well for you and yours. To determine the maximum effective range of a choke/load combination for wingshooting, start by shooting paper at 20 yards and then back off from the pattern board in five-yard increments, shooting patterns at each range.



Once you see the percentage of shot inside a 30-inch circle drop below 65 percent you have exceeded the maximum range for that particular combination. While I realize it takes only one pellet through the brain or spine to drop a bird for keeps, I also realize it is possible for all pellets to miss those targets and if that happens multiple pellet strikes will usually deliver enough energy for a clean kill.



Chart 4
Approximate Effective Pattern Diameters (In Inches)
10 Yds 20 Yds 30 Yds 40 yds
Spreader 23" 37" 51" 66"
Cylinder Bore (no choke) 20" 32" 44" 57"
Improved Cylinder 15" 26" 38" 51"
Modified 12" 20" 32" 46"
Full 9" 16" 26" 40"

Tis should help. I did take time to straighten out al the charts as the first one seemed to suit your question best.
Shoot safe.
http://www.wildfowlmag.com/tips_strategies/shotgun_062304/

Answer 2

Choke Tubes Chart

Answer 3

Modified, improve modified or full... I've shot all three from 16 yards and IM and Full from handicap and all work well.

What you'll have to decide is what loads work best in your gun with which choke. I've shot 25 and 50 straight 16 and handicap with a full, and just started with an IM and shoot consistent 23 and 24's. I've even taken the IM back to the 27 yard mark and shot 22 out of 25.. heck I've gone two extra yards on our field to about 29 yards and can shoot IM at that distance...

You don't need a fancy trapgun to shoot -- all you need is one that fits, and one that you are comfortable using. If you are fast, the more open choke you will want, if you let it get out and break it when it floats, use full.

As a general rule of thumb use 8 shot from the 16 yard line in a 2 3/4 dram eq. light target load, and from farther back, use 7 1/2 shot for handicap... After using several, I found AA Light Targets (1145 fps) are best for 16 and Remington's Nitro Handicap (1235 fps) are best for handicap. I also like Remington's light 1 ounce 7 1/2 shot game loads for handicap (1290 fps).

For doubles, if you have an over-under, you can use a light target load with 9 shot (or 8) through a modfied for the 1st bird, and a load of 8 shot throught an Improved Modified for the second bird.

Practice, have fun, be safe!

Answer 4

Briley Choke Chart

Answer 5

Due the distances, wind conditions, air temp and humidity, you can encounter while shooting trap you may want to purchase a full set of chokes. I have a number of friends who are Triple A trap shooters and they all have full sets for their guns. And change as often as conditions require.

For the best answers, search on this site https://smarturl.im/aDAez

Answer 6

Anything from Improved Modified from the 16 yard line....to extra full from any of the handicap yards.

If you know exactly where your pattern is at forty yards....best to shoot with the same choke tube at all yardage.

Answer 7

To my knowledge, you would want to use a modified or improved cylinder choke for shooting trap

Answer 8

I always use a full choke when I shoot Trap.

Answer 9

Penny stocks are loosely categorized companies with share prices of below $5 and with market caps of under $200 million. They are sometimes referred to as "the slot machines of the equity market" because of the money involved. There may be a good place for penny stocks in the portfolio of an experienced, advanced investor, however, if you follow this guide you will learn the most efficient strategies https://tr.im/c8109

Answer 10

which briley choke tube for a 20 ga for a youth?

Answer 11

I'm earning good money with this binary option signal sofrware ( www.forexsignal.kyma.info )

What I'm going to show you now might irritate old-fashioned traders who can't accept that a piece of software can outperform what they have learned through many years of trial and error