I have a dryer with a 3 prong plug.How do I plug into a 4 prong outlet?

Answer 1

As stated earlier you need to purchase a 4 prong plug at the hardware store and switch out the 3 prong one. I've included a diagram and color coding on exactly how to do this.

http://www.american-appliance.com/service_pages/electric_dryer_cord.htm

Answer 2

was once user-friendly home equipment did not desire a impartial so it became 240 volt and a floor. we've digital controls that choose a hundred and twenty volts to impartial alongside with the 240 volt and floor. (Your panel has 2 stages of a hundred and twenty volt that as quickly as blended mutually make 240 volt between them. the two a type of stages will make a hundred and twenty volt to impartial) The NEC does not choose human beings utilising a floor twine for a impartial regardless of the incontrovertible fact that this is committed, it provides the flair for the chassis to have stay present day recent. in any case, this is good which you have a 4 prong outlet. it would be least puzzling to alter the twine to a 4 twine one. on the back of your dryer there's a small steel door often held with 2 screws. interior you will see a terminal strip with some screws protecting down the twine ends. often the middle screw is your impartial and the two area is your hots. the floor would be without delay above or under the impartial (green screw) and with a three prong twine, there must be a copper jumper between the floor and impartial screws. you ought to get rid of this to isolate the impartial. (if your dryer is so old that it does not have a impartial screw, it became probable equipped a heck of lots better than the crap we purchase immediately, and additionally you do not connect the white twine to something. merely confirm it could not by twist of destiny discover this is thank you to touch the nice and cozy terminals.) Wait till you have linked the terminals formerly tightening down the twine protecting clamp the place the twine exits the case.

Answer 3

Due to recent changes in the NEC new receptacle installations for dryers and stoves now have to be grounded, hence the fourth prong. The safest way to handle the problem is to change the cord on the appliance. When you open the cover where the cord connects to the appliance terminals you will see that the center terminal with the white wire attached to it. You will see a bonding jumper from the terminal to a grounding (green) screw (usually a flat piece of copper). Remove this jumper and connect the white wire from the new cord to the center terminal and the ground(green) wire to the green terminal or screw. If you feel uncomfortable doing this by all means call a qualified electrician or appliance repair man.

Answer 4

Easy just go to the hardware store and buy a 4 prong dryer cord and hook it to the dryer. the hookup is the same it just has two (2) grounds.

Answer 5

You have to switch out the outlet or get an adapter. Whatever you do, DO NOT cut a prong or try to bend it in, you have to get them to match before you plug it in.

Good luck and be careful!

Answer 6

You need an adapter for sure. Home depot, Ace hardware, target, walmart.... yadda yadda... they all have one. You can even find it at your local grocer.

Btw, if in Europe, then disregard all of the above.

Best Wishes!

Answer 7

sounds to me like you need a 220 outlet.

Answer 8

You don't without an adapter.

Answer 9

you cant unless you buy another peice or extender

Answer 10

YOU HAVE TO CHANGE THE PLUG,