2006-07-06 14:56:52 · 11 answers · asked by Sam 1 in Home & Garden ➔ Maintenance & Repairs
Cut with the finish side up. Use masking tape over area to be cut. Do not push the plywood through blade too quickly, and yes, use a fine tooth blade designed for cutting plywood.
2006-07-06 15:06:19 · answer #1 · answered by Don 6 · 2⤊ 0⤋
Tape the line you are cutting and a plywood blade.
2006-07-06 15:03:33 · answer #2 · answered by Josh S 7 · 0⤊ 0⤋
You need a very sharp blade,,look for a masisushita brand,,,if you are cutting across the grain,,you will probably get some splintering anyway,,so put the side you want to show,,DOWN while cutting
2006-07-06 15:03:10 · answer #3 · answered by Anonymous · 0⤊ 0⤋
i usually score the plywood with a utility knife then cut from the opposite side, if using a circular saw, table saw, cut finish side up
2006-07-06 15:50:14 · answer #4 · answered by maintman 2 · 0⤊ 0⤋
use a very sharp blade and one thats made for plywood. lots of teeth
2006-07-06 15:00:15 · answer #5 · answered by xjoizey 7 · 0⤊ 0⤋
i use a straight edge on cut line and score 1/8 inch deep with utility knife works perfect for ply with a veneer surface
make sure utility blade is new
and keep other hand away from blade path in case knife slips
2006-07-06 15:11:23 · answer #6 · answered by charleybgoode 2 · 0⤊ 0⤋
Try lining your cut area with painters tape before cutting.
2006-07-06 15:03:30 · answer #7 · answered by fdchagnot 1 · 0⤊ 0⤋
Use a blade with at least 100 tooth and put the good side up.
2006-07-06 15:25:06 · answer #8 · answered by Handyman 4 · 0⤊ 0⤋
lower the blade on the saw it should go threw the other side just a little and you can duct tape the wood it and the splintering should stop
2006-07-06 15:02:19 · answer #9 · answered by macki4 4 · 0⤊ 0⤋
Apply masking tape to where you want to cut and cut through the tape too, it supports and protects the veneer.
2006-07-06 15:01:51 · answer #10 · answered by AngryMarvin 4 · 0⤊ 0⤋