im doing dry wall andneed to know how to put joint tape on?

Question

the tape is just paper

Answer 1

I agree with Murph for the most part, with one addition:
You should apply the last layer of mud in a much more liquid consistancy than the previous layers (similar to mayo...). Feather this thin layer with your mud knife and let dry.
This will help to hide tape lines, especially if you aren't planning on texturing.

Answer 2

1st apply a layer of drywall mud along the joint.
2nd lay the paper on the mud. the longer the piece the better.
3rd using your tape knife bed the paper into the mud and remove any excess.
4th alow this to dry.
5th & 6th apply 2 more coats allowing each to dry before applying the next.
7th. sand smooth
8th prime with drywall primer
9th paint...2 coats of good latex paint.
10th enjoy!!
good luck

Answer 3

put a little mud at the joint, then put on your tape. finally mud over. I recommend mesh, easier to use.

Answer 4

Usually you just soak it in water for a little bit, and slap it on. Then when it dries you paint, or plaster over it.

Some brands use a special glue though. Ask your hardware store, it usually works a little better.

Answer 5

Put some spackle over the joint, they put your tape over it, then run your trowel over it with more spackle, then feather out.