I have taken my steering wheel apart but I cannot get the ignition out and it will not turn in any direction
2006-06-27 15:25:07 · 5 answers · asked by souixpersize 1 in Cars & Transportation ➔ Car Makes ➔ Ford
If it doesn't turn and you cant get the ignition out then you have to drill the pin out of the ignition that holds it in place. If it won't turn sounds like the steering lock is in a bind keeping the ignition from turning.
2006-06-28 15:35:30 · answer #1 · answered by Josh S 7 · 1⤊ 0⤋
after you pull the wheel and stuff off you,ll see plate that contain,s the turn signal switch,,remove the three screw,s from it and slightly pull out on it,,behind it you ,will see a screw that goes in above the ign-switch,,remove it,,and you can pull the switch strait out,,now this providing that you have removed the lock plate that is in front of it,,if you have removed it,,then you should,nt have any problem,s,,if you have,nt,,you,ll have to rent a tool to remove the plate with ,,or buy one there not very much,,and it does make the job go a lot easier,,just take your time and you,ll get it,,hope this will help you.
2006-06-27 17:11:21 · answer #2 · answered by dodge man 7 · 0⤊ 0⤋
well the way the ford igniton swiches come out is that they have to be in the run positon and you push a pick up this lil hole on the underside of the colom if you cant turn it get a lock smith im telling you if you try to chisle it out its goning to take you forever and your just going to ruin the housing i have done it before
2006-06-27 15:34:38 · answer #3 · answered by ilikecheezeburgers 3 · 0⤊ 0⤋
They are different in different cars. Get a Chiltons manual for your car and it will have complete directions.
Haynes also makes a good manual
You can sometimes find them in the library
2006-06-27 15:33:50 · answer #4 · answered by mapleguy 7 · 0⤊ 0⤋
what type of ford is it need more specifics
2006-06-28 07:59:43 · answer #5 · answered by Anonymous · 0⤊ 0⤋