water flow problem.?

Question

when i have the shower o, if someone flushes a toilet or uses a faucet in another part of the house, the water heat suffers substantially that you cannot do two things at one time that require flowing water. Vice versa as well. what could the problem be? i have a 50 gallon water heater. do i need a pressure increaser or something?

Answer 1

there are too many variables, you NEED a plumber!

Answer 2

If the water piping is old galvanized pipe, that is one possible cause, and there isn't any easy fix short of a re-pipe. If the water piping is under-sized, that's another possibility (same fix). If the pressure is low, and you're on municipal water, the water dept *might* do something about it. You can check the water pressure with a pressure gauge - about $10 at a hardware store (it'll screw onto a hose bib). 40 psi or less is marginal.

It could also be something simple, like a valve that isn't open all the way, or a pressure regulator that's failing.

You should get a couple of plumbers over to look at it & give you a free estimate. An on-site inspection will point you in the right direction.

Answer 3

Most newer shower facets are equipped with an equalizer mounted in them for safety to prevent that from happening. i.e. if someone flushes the commode the pressure shoulder equalize so the shower doesn't go cold all you should notice is maybe a small decrease in pressure.
It could be the equalizer has gone bad.
It can be replaced if the fixture is not too old or not an off brand where there are no spare parts avaible for it.
If you can't get replacement parts you will have to change the whole fixture (facet). Or if it is an old unit without an equalizer you will need to change it as well.
If you are not versed in how to do plumbing work you will need to call a plumber.

Answer 4

If the water piping is previous galvanized pipe, it extremely is one conceivable reason, and there is not any hardship-loose restoration needing a re-pipe. If the water piping is under-sized, it extremely is yet yet another threat (comparable restoration). If the strain is low, and you're on municipal water, the water dept *might* concentration on it. you are going to be able to nicely be taught the water stress with a stress gauge - approximately $10 at a ironmongery keep (it extremely is going to screw onto a hose bib). 40 psi or much less is marginal. it would additionally be some thing undemanding, like a valve it extremely is no longer open each and each of ways, or a stress regulator it extremely is failing. you are going to be able to get a pair of plumbers over to seem at it & furnish you a loose estimate. An on-internet site inspection will ingredient you interior the mind-blowing path.

Answer 5

Usually thats a common problem anywhere because you get water from one main line it branches out to other fixtures such as kitchen sink bathroom sink and shower which ever fixture is the closest along your waterline that fixture will get more hot water than the others ex say along your line it is fed into the kitchen first then the bathroom sink then the shower if someone was to use the kitchen sink that would deprive both the bathroom sink and shower of hot water.The only way to correct this, is if you have old galvanized plumbing usualy those supply lines are only 1/2 inch in diameter if you were to upgrade to copper now days supply lines are 3/4 inch in diameter which allows for more water flow.

Answer 6

There is some kind of restriction in the hot water line, or the cold water line feeding the water heater.. It could be just a long distance, too small piping, a partially closed valve, or a combination of these.

Answer 7

probably find your pipes and water heater are blocked up with rust and gunk might try reverse flush of your water heater
and low water fill in cistern and put a brick in it