2007-12-26 14:59:01 · 3 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
just about the easiest thing to do.
Remove the neg (-) cable from the battery.
Remove the pos (+) cable from the solenoid.
Remove the starter cable from the other side of the solenoid.
Remove any other wires that may be attached to the solenoid, being sure to note their location for re-installation later.
Remove the solenoid from the firewall or fender (depending on location).
Installation is the reverse of the above.
Good luck!
2007-12-26 15:07:53 · answer #1 · answered by Doug K 5 · 2⤊ 0⤋
Should be on the passenger side of engine compartment roughly a foot behind the radiator core support. has 2 hex head sheetmetal screws holding it on, has 2 wires with push on connectors, 2 larger wires with eye type ends that connect to battery and starter (held w/nuts on copper studs). Unfasten wires, unbolt from side. Reverse to install.
If U should reverse the 2 smaller wires-just won't start. Pretty hard to reverse the stiff batt/start cables.
2007-12-26 15:16:26 · answer #2 · answered by stanly s 4 · 2⤊ 0⤋
It's on the fender. Disconnect the neg. cable from the batt. and change the solonoid.
2007-12-26 15:16:37 · answer #3 · answered by Bob H 7 · 0⤊ 0⤋