2007-12-26 13:58:03 · 5 answers · asked by Anonymous in Home & Garden ➔ Do It Yourself (DIY)
First open the jaws of the chuck as wide as they will go, and look down in the center. There should be a screw, either flat blade or philips, that's holding the chuck on the shaft so that it won't unscrew as you're drilling. It's usually a left handed thread on the screw, so it will have to be turned clockwise to loosen. Once that is out, get as large an allen wrench as you can find and put the short end in the chuck jaws. Tighten them down good and tight, then secure the drill in a vise, firmly, but not too tight so as not to damage the motor. Try tapping the long end of the allen wrench with a hammer to loosen the chuck on the threads. Some drills have a left handed thread on the chuck shaft as well as the attaching screw, others are right handed. You just have to try both ways till it comes loose. Once it breaks loose, of course, you can then unthread it and take it off.
2007-12-26 14:14:50 · answer #1 · answered by Corky R 7 · 2⤊ 0⤋
Beleive it or not, it is friction fitted to the drill.
You need to gently hit the chuck in the opposite direction from the drill.....you will end up with the drill and a chuck...in two pieces.
2007-12-26 14:16:35 · answer #2 · answered by bob shark 7 · 0⤊ 1⤋
Could be either way,,,cordless drill USUALLY have a screw in the center f the chuck. No brand name or model #. No more research possible without info.
2007-12-30 12:33:11 · answer #3 · answered by oldman49_2000 5 · 0⤊ 0⤋
I cannot answer your question. However, if you take your drill to the tool dept. of a large store like Home Depot or Lowes, I am sure they will help. They may even do it for you.
2007-12-26 14:04:42 · answer #4 · answered by ijcoffin 6 · 0⤊ 0⤋
what bob shark said
2007-12-26 14:37:28 · answer #5 · answered by US!!!*** I think 2 · 0⤊ 1⤋