how to use the crimper?

Question

im confused with the wirings,, how can i make a crossover connection? i hav a 5meter UTP cable and 2 RJ45... thats all thank you and have a blessed christmas!!!

Answer 1

Well you need to check these photos so you know what wires go where first.
http://www.duxcw.com/digest/Howto/network/cable/cable5.htm
and a step by step for crossover
http://www.littlewhitedog.com/content-8.html

Once you have the ends stripped back about 1/2 inch lay out the wires in a flat "fan" of the colors as needed. Follow the picture for a cross over. Slide that fan into the back of the RJ45's and be sure the ends reach into the very front end of the connector. Then put the connector into the crimper, it will only fit one way. Squeeze the handle, if its the racheting type it won't release until the ends are crimped, if not just be sure you close the handle tightly. Remove the RJ45 from the crimper and look at the end. Make sure the cables are "pushed" through. You can see this by looking at the front end of the RJ45 - if you look close, you will see where the pins are pushed through the cable.

Hope that helps,
Merry Christmas and God Bless