like what comes in the lil kit you use to put it on your windows
and also are you supposed to use oil to slick the tint on?
2007-12-22 15:33:32 · 6 answers · asked by tocrunkforu2004 1 in Cars & Transportation ➔ Other - Cars & Transportation
Here's what you really need:
1. Money to burn since the store stuff turns purple.
2. An appreciation for these purple windows.
3. Bubbles and creases. .you'll see!
4 How about that rear window- -can ya' do it in one piece?
Go to a dealer like LLumar at http://www.llumar.com These business owners know tint and you get a lifetime warranty!
If you buy cheap- You buy often.
2007-12-22 21:14:08 · answer #1 · answered by Mike F 6 · 0⤊ 0⤋
Get a plastic spray bottle, fill it with water and detergent. Take your door trims off. That will allow the tint to go below the door trims and not be seen - looks better. Cut the tint roughly to size. Spray the window with the water/detergent mix and place the tint on the window. The detergent will allow you to move the tint around until its in the correct position. Use a hair dryer (or heat gun if you have one) to dry the tint. This will also allow the glue on the tint to become sticky. Don't over heat. With a very sharp razor blade, trim the tint. Be careful not to slip!!! Use a ruler to guide the cut. Slow and steady. You can take the tint to the edge of the window and then just cut the overlap - easier. Use a plastic card (credit card) to move air bubbles to the sides of the window area.
2016-05-26 00:11:03 · answer #2 · answered by ? 3 · 0⤊ 0⤋
You dont need oil. The tint is self stick, get a empty spray bottle and fill it with soapy water (makes it easier to make adjustments to tint if neccessary. Make sure the window is clean, then spray with the soapy water. Apply the tint, take your time... Trim any leftover areas of tint with a sharp razor blade. (using a dull blade increases the chances of messing up. Once applied and trimmed, use a squeege to smoothen out the tint film, "push" any air bubbles to the outer edges of the window until they are gone. (Dont use a id/credit card to do this process, the card is too thick and can rip the tint easily) Hope this helps. Good Luck, Its not as easy as it sounds.
2007-12-22 16:16:58 · answer #3 · answered by nmracing 2 · 0⤊ 0⤋
you need the tint, dish soap, and a squeegee, along with a razor blade to cut the tint
2007-12-22 15:42:04 · answer #4 · answered by Bob S 3 · 0⤊ 0⤋
there are two ways to doin this you can make it on your own or buy it at the store for example buy it at wal*mart i got mine there
2007-12-22 16:21:34 · answer #5 · answered by Yesenia Gonzales 1 · 0⤊ 0⤋
The above....
and a whole lot of patience.
2007-12-22 16:16:32 · answer #6 · answered by don_sv_az 7 · 0⤊ 0⤋