got slight vibration on the gas peddle when i pull away hard any ideas why
2007-12-20 17:26:30 · 8 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ Mitsubishi
Got a bad roll stop? Too much motor torque can cause vibration in the exhaust and resonate through the cables.
2007-12-21 01:26:28 · answer #1 · answered by thebax2006 7 · 1⤊ 0⤋
Engine out of tune. Clutch slipping. Engine/gearbox mountings.
2007-12-20 19:15:21 · answer #2 · answered by champer 7 · 2⤊ 0⤋
at the front of the impalas are what's termed a wheel hub assy.it is a form of wheel bearing.Please have the left the front hub checked once a possibility.at the same time as those wheel hubs flow undesirable they reason noise and vibration.best of success.
2016-10-19 21:55:54 · answer #3 · answered by ? 4 · 0⤊ 0⤋
lots of things, maybe an imbalance in the engine suggesting wear, bad air/fuel mix leading to pre-ignition, steering wear in the column bearing and or tyre wear but i think most likely is engine mounts being eroded or broken, how old is the car/engine and the miles it's done?
2007-12-20 17:47:47 · answer #4 · answered by Anonymous · 1⤊ 2⤋
Your gas pedal cable might be getting loose. Get it checked.
2007-12-20 17:33:40 · answer #5 · answered by Peter P 4 · 0⤊ 1⤋
if everything is 100% with the motor,it will be air intake only,this is the fault you engine needs more air
regards x kitti x
2007-12-20 22:40:48 · answer #6 · answered by misskitti7® 7 · 0⤊ 1⤋
Its a combustion problem in your engine check your air filter doesn't need changing
2007-12-20 17:34:47 · answer #7 · answered by Anonymous · 0⤊ 1⤋
tyre problem?
don't pull away quite so fast.
2007-12-20 17:48:08 · answer #8 · answered by Carol B 5 · 0⤊ 2⤋