English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

I have a 1984 GMC serria 1500 rebuilt a 350 and threw it down in it. now it over heats really fast. what could make it do this ? plus i notice the oil looks milky and white creamy looking stuf, , what would be any reasons for this ?

2007-12-19 09:30:36 · 18 answers · asked by Ashley 1 in Cars & Transportation Maintenance & Repairs

18 answers

You've got coolant in your engine oil. You've cracked the block / or cylinder head / or head gasket. That is a virtual death sentence to an engine. You need to get a new engine

2007-12-19 09:37:53 · answer #1 · answered by Anonymous · 3 0

If you rarely drive more than a few miles at a time, so the engine is constantly running cold, it can be normal (except the oil leak, of course). In that case the coolant is not disappearing (you don't mention coolant loss), or is disappearing for another reason. Gasoline produces right at a gallon of water for every gallon of gas burned and it is inevitable some of that water will end up in the oil. If the engine is not regularly heated enough to boil the water off it makes the stuff you see. Some people are shocked to see their oil level drop a quart in a couple hours of freeway driving - the water is boiled off. Anyway, if coolant is not disappearing that is what is happening... guaranteed. But you need to find the leak. The best clue is the part of the engine compartment the puddle is forming under. Newspaper under the car is a good way to get that figured out, then go from there.

2016-05-25 02:05:00 · answer #2 · answered by janell 3 · 0 0

sounds like you may either have a warped head or a gasket problem either way that is your coolant leaking into your engine oil making it look milky. you must have overheated it pretty bad before. i would be willing to bet you were driving down the road one day and it got really hot and the car started to slow down and no matter how hard you pressed the gas it just kept on slowing down. you probably warped the top part of your motor. lot of money to get that fixed. good luck

2007-12-19 09:39:17 · answer #3 · answered by dirty 1 · 1 0

The head gasket is leaking. Possibly because the head bolts weren't tighted down properly. Drain the oil and get the head gasket replaced before you drive that truck anywhere.

2007-12-19 09:37:31 · answer #4 · answered by soaplakegirl 6 · 0 0

You have a leak between the oiling and cooling system. Could be a head gasket, cylinder head or crankcase. Hope it's only a head gasket.

2007-12-19 09:37:18 · answer #5 · answered by Johneye 4 · 2 0

Your cylinder head is cracked. Coolant mixing with the oil causes that milky looking stuff. Sorry

2007-12-19 09:38:26 · answer #6 · answered by ? 4 · 1 0

you have a blown head gasket or the head is warped ummm its not cheap to fix but you might not need a new mottor ummm what going on is water is leaking from you cooling system to the cracked gasket or warped head and its leaking in to the oil

2007-12-19 09:39:20 · answer #7 · answered by robert s 1 · 0 0

either a leaking head gasket or a cracked head or block. Pull the heads and check your gasket real close for any tracking signs.

2007-12-19 09:39:31 · answer #8 · answered by scrambledmolecues 3 · 0 0

Chances are very good that if your engine was re-built that your heads could be cracked. Most later model 350 heads are too thin (to save weight) to endure rebuilding and need to be replaced instead of re-built. Are you blowing smoke out the tailpipe???

2007-12-19 10:06:06 · answer #9 · answered by Robert M 7 · 0 0

you have a bad head gasket, replace the head gaskets and change the oil and filter and refill the anti-freeze and you should be good to go.

2007-12-19 11:42:32 · answer #10 · answered by mister ss 7 · 0 0

fedest.com, questions and answers