Help !!! Washer keeps overflowing at drain pipe?

Question

when my washer starts emptying it runs over where the drain is inserted in the drain pipe. It doesn't do it all the time, I don't think the drain is clogged, but i guess its a possibility.

Answer 1

get a Snake
run it down the pipe

Answer 2

Discharge water from washers contains lots of lint. It can clog the piping or trap on the drain. A small diameter snake can be ran down the standpipe to clear. Newer washers have more powerful pumps and the Plumbing codes are being changed to 2" drain lines from the current 1-1/2".

Answer 3

confident, the P capture is what prevents sewer odors getting into your place. and you do no longer choose that. is this difficulty drain 2"? And, is the standpipe extreme sufficient? those are the plumbing questions i might have, and that i might could make specific this pipe and vent have been snaked, just to confirm there's no clog or obstruction. In gaining knowledge of this, i found online a minimum of a few people who've dealt with this difficulty by potential of installation a restrictor piece interior their washer drain hose, so the water could no longer flow so quickly. there develop into debate on the communicate board no rely if or no longer this might bring about untimely motor and/or pump failure, with some asserting they had finished this and it labored high-quality, and others predicting failure. If i develop into desperate, i might attempt it.

Answer 4

alot of houses in atlanta area have washer drains and kitchen sink drains connected, you can buy a 1/4 " snake fairly inexpensive at big box store to remove lint but if kitchen drain grease is culprit you may want to call a tool rental place and see about renting a 3/8 to 1/2" snake. take on top of roof ( if 1 story house) and run snake down vent

Answer 5

Like the other guy said, get a snake. they are relatively inexpensive and easy to use. I had the same problem sometimes it overflowed, sometimes it didn't. There is really no other good explanation for the overflowing.

Answer 6

snake it. then wrap a nylon stocking around the water discharge and use a circle clamp to secure it (leave about 3" of slack). it will catch the lint, just replace it every once and a while.