When i stepped on my powerr serg my computer when off.When I turned it back on I got a blue screen.Well I went into system setup and change something to RAID ON.Well it works now,but when I go to reformat it it say No hard disk installed.What do I do.Please Help
2007-12-13 15:49:39 · 4 answers · asked by johnny_vaughn13 1 in Computers & Internet ➔ Hardware ➔ Other - Hardware
Two possibilities that I can think of are:
1) Your internal CMOS (clock) battery was fried in the serg. For some reason replacing your internal battery will get your hard drives back working. I don't know how this is but it was covered in our local paper in the tech section a while back.
2) Reinstall JMICRON Driver. Should be on your installation disk. This will give it factory settings but you should then upload to the newest JMicron Driver. This is what recognizes your hard drives.
2007-12-13 16:10:24 · answer #1 · answered by memberrw 3 · 0⤊ 1⤋
Check on the IDE cable just pull it up on both sides one at a time then return it back again.
It maybe just lossen up and has no connection to your hard disk.
Check also other cable connectors and your plugs. They must not be move this will cause disconnections.
2007-12-14 00:02:28 · answer #2 · answered by Johann C 4 · 0⤊ 1⤋
knock the raid off.. to have raid you have to have a minimum of two Hdd installed in the system.
you may have blown your hard drive but more likely have lost the boot sector,, so boot up your system and hit the key that gets you into the bios check that it sees your hard drive,, if it dose then you will need to reinstall windows again, if it dose not see he hard drive then it is a case of you buying another hard drive...
2007-12-14 00:07:38 · answer #3 · answered by Carling 7 · 0⤊ 1⤋
Call Tech Supprt!
2007-12-13 23:55:48 · answer #4 · answered by Anonymous · 0⤊ 2⤋