Maybe M7 but I think it's closer to an M5 fine pitch. HOWEVER...these are only close. The thread pitches between UNF and metric are not compatible.
2007-12-11 00:02:55
·
answer #1
·
answered by tamarack58 5
·
3⤊
2⤋
Up to the 1950' - ish British car threads were BSF. British threads were based on the diameter of the bolt, American ones were measured across the flats of the nut. Some Austin/Morris engines were American but the chassis was British! Some Morris cars before the war were a bastardised BSF in that they had two more threads per inch than BSF of a similar diameter. Buy a few nuts and bolts on the web and simply try them for size. BTW Pipe threads used for brake pipes and petrol lines were and remain copper BSP so you should not have problems there. RoyS
2016-05-23 00:59:36
·
answer #2
·
answered by ? 3
·
0⤊
1⤋
There is no such thing. 10-32 means a #10 SAE size with 32 threads per inch. If SAE and metric were interchangeable, we'd all only use one system (preferably metric).
2007-12-11 01:04:02
·
answer #3
·
answered by Anonymous
·
4⤊
1⤋
5mm-.08 is very close. Its just a little bigger. 10-32 bolt will fit a 5mm nut but will strip if u tighten it down. They get confused a lot but use the right one. I always figure if its not made in USA its metric.
2015-05-26 15:07:14
·
answer #4
·
answered by adampadamadam 2
·
1⤊
0⤋
There is no match.
The closest metric screw would be an M5 x .80
2007-12-11 08:19:42
·
answer #5
·
answered by Firecracker . 7
·
2⤊
0⤋
please guid to me 10-32 unf thread screws to metric nut & 1/4-28 unf thread screw to metric.
2015-02-26 18:00:48
·
answer #6
·
answered by neel 1
·
0⤊
0⤋
hay it closest match is 8mm x 100 tpi but metric and American standard ARE NOT INTERCHANGEABLE
2007-12-11 00:08:41
·
answer #7
·
answered by Anonymous
·
4⤊
2⤋
7 mm. Time to get civilized!
2007-12-10 23:43:24
·
answer #8
·
answered by Anonymous
·
0⤊
4⤋
No, don't have, it can't be transfer exchanged,
hppp://www.gaugestools.com
2014-08-30 00:30:40
·
answer #9
·
answered by Anonymous
·
0⤊
1⤋