ZZR600. New stator, Cover, starter, and battery
2007-12-01 00:40:44 · 13 answers · asked by djm749 6 in Cars & Transportation ➔ Motorcycles
New batteries require charging before installation.
Is it fully charged?
Check the wiring from the battery through the starter solenoid to the starter for clean, tight connections. Also check the negative side to ground.
That's the simple stuff.
Your starter may be bound up. Out of alignment during installation will do it.
2007-12-01 06:51:55 · answer #1 · answered by Firecracker . 7 · 0⤊ 0⤋
Check all connections and have battery checked. If all that checks out ok, I would check the selnoid (however its spelled). If that is clicking over ok, then most likely your battery. I've never dealt with motorcycles, but cars work along that path. And as the saying always goes, its always the last thing you check. Good luck hunting!!!
2007-12-01 00:52:39 · answer #2 · answered by daddytotwins 2 · 1⤊ 0⤋
Check the starter solenoid and that all wires are tightly secured. If the solenoid is bad, you'll have enough power to it, it's just not engaging the starter. If the wires are loose, corroded, or broken, you won't be getting enough power to the solenoid.
2007-12-01 00:56:15 · answer #3 · answered by haditwithstupidpeople 2 · 1⤊ 0⤋
Sounds like the battery cables are loose considering everything you added is new. One way to check is to see if the headlights turn off when trying to start it. If it does, then your battery is drained or cables are not secured.
2007-12-01 02:10:29 · answer #4 · answered by ajponu 4 · 0⤊ 0⤋
relatively that's the battery, the clicking sound is the solenoid. you merely would have a bad connection in between the terminals. make helpful all connections are tight and the amperage is actual on your motor vehicle. make helpful the connections to the floor are tight as properly, this can be the difficulty from what you defined.
2016-11-13 03:16:13 · answer #5 · answered by Erika 4 · 0⤊ 0⤋
1. Battery is low or bad.
2. Started needs replacing.
3.Loose battery cables.
4. Other wireing is bad or loose.
2007-12-01 01:30:11 · answer #6 · answered by Date Dr. 6 · 2⤊ 1⤋
have you checked the ground wires , both ends at battery , and engine / frame . also make sure all connections are tight , your getting power , but it may not be enough to turn the motor
2007-12-01 00:49:57 · answer #7 · answered by crazy_ol_hippie_radical 6 · 1⤊ 0⤋
Battery's toast, sylonoid's fried, or you've got crap cables. of those, I'd start with the battery cables. How old is this bike? Bet on the wires.
2007-12-01 05:21:22 · answer #8 · answered by JustJoshin999 3 · 0⤊ 1⤋
it's either a bad solenoid switch on the starter, or the more likely scenario is a poorly charged battery.
2007-12-01 00:49:34 · answer #9 · answered by Anonymous · 1⤊ 2⤋
Alternator???/
2007-12-01 00:43:48 · answer #10 · answered by Anonymous · 1⤊ 3⤋