2007-11-30 00:15:50 · 5 answers · asked by g3rald0d0 1 in Home & Garden ➔ Do It Yourself (DIY)
run verticle supports from floor to ceiling. Attach them to the floor with aluminum angle and then at the top. then, attach shelves to the verticle supports.
Supports can be made of wood or aluminum rec tubing.
Yoda out
2007-11-30 01:10:19 · answer #1 · answered by Yoda 5 · 0⤊ 0⤋
attempt to align the holes into mortar particularly than the brick. Mark each and every of the holes with the shelf point with an eternal marker. From a ironmongery keep, acquire lead anchors, as properly because of the fact the screws that extra healthful into it. the burden on the shelf would be certain the scale and frequency of the anchors. utilising a masonary bit, drill holes of length as prescribed for lead anchors. Use a reliable epoxy and positioned the anchor in, doing so rapidly because of the fact the adhesive dries speedy.Then carry the shelf up andpersistent the screws in. this gadget won't injury the mortar and is amazingly reliable, yet will of path depart anchors at the back of in case you do away with the shelf later. The anchors are silver/gray, however, so as that they don't seem to be that seen. The blue Tapcon® fastners paintings properly in concrete, yet not so properly in brick because of the fact the stone oftentimes cracks.
2016-10-09 22:57:58 · answer #2 · answered by Anonymous · 0⤊ 0⤋
I run vertical 4X4's down the walls and made sure these were affixed good, then attached the shelves.
2007-11-30 01:41:47 · answer #3 · answered by cowboydoc 7 · 0⤊ 0⤋
No offense; but I suspect "my" concern would be first to remediate the walls; long before I decided to add further stress to them.
2007-11-30 00:31:37 · answer #4 · answered by DIY Doc 7 · 1⤊ 0⤋
try a resin made for this purpose this resin will allow you to join on to concrete great stuff .
2007-11-30 00:22:33 · answer #5 · answered by david p 3 · 0⤊ 0⤋