ok i was wondering how do i log into my router its 2wire but i forget the specs of it i have sbcglobal and windows xp i tryed all that other stuff put ur ip into the address bar and it doesent work what should i do to log into it
2007-11-26 09:55:01 · 3 answers · asked by Anonymous in Computers & Internet ➔ Computer Networking
Try these two either should work unless you changed some things
http://gateway.2wire.net/
http://192.168.1.254/
Just click them and see if you see your router. You should
If not you may simply not be connected.
If all else fails use the support at
http://2wire.com
Good Luck
2007-11-26 10:43:27 · answer #1 · answered by Tracy L 7 · 0⤊ 0⤋
go to command promt and type ip config. Look at the gateway address make sure that it is the same Ip address that you have been using to log in. Then make sure that your ip is set dhcp. If this doesn't work try unplugging the router and reseting it. but usually it is an ip conflict.
2007-11-26 18:11:51 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Read the instructions on the bottom of the router. IF that doesn't work, contact AT&T support.
2007-11-26 17:59:37 · answer #3 · answered by Jag 6 · 0⤊ 0⤋