1995 Jeep alarm system will not let me start truck. Alarm goes off with key but alarm goes on when cranking?

Answer 1

stock alar can be disabled by locking the doors all of them with the key and unlocking them passanger as well as back door
if its an after market one good luck i had one do it last week i finally cut it out of the systen go under the dash you will see 1 wire that was cut and both ends spliced to other wires re hook that wire back now under the hood ther is a wire that was added that runs to the ignition coil cut it you should be able to start the car now

Answer 2

Make sure the door locks are in open position. Use master lock at driver seat to open all locked doors.

Start the car and then lock the car while inside to test it.

If this does not work, read the owner's manual.

Still no go have it towed to the dealer if you can not drive it.

Some car will shut off after a block or so of driving and some will reset itself.

This is in the book also.

Do not have a book call dealer and get the link on the Internet.

See what happens.

Answer 3

Disconnect alarm system!