Hot water, (Hydronic), heating with Gas is a
pretty robust system.
No filters to change.
You might 'bleed` the radiators to check for
air pockets, (DIY), and have the burners and
chimney checked once a year, (by a Pro).
There will be a circulator pump that runs when
the system is heating. If this gets noisy, it's a sign
of trouble.
Otherwise, "If it works, don't fix it."
To bleed the radiators:
(Dissolved air tends to collect in them.)
There will be a small fitting, like a mini-faucet
with a screw-slotted stem on each radiator.
Just hold a small container under the spout,
and loosen the screw until some water drains,
then tighten it again.
2007-11-15 13:52:03
·
answer #1
·
answered by Irv S 7
·
0⤊
0⤋
It sounds like you need some preventitive maintenance. If you are hearing an unfamiliar sound when the gas kicks on it sounds like the ignition systen for the gas is kicking on a lot later than it should. When the furnace turns on the igniter should be glowing or the spark should be popping before the gas valve opens. If it allows the gas to open too soon and fills up the chamber with gas, you could get a very nasty ignition in the furnace or small explosion. Almost like filling a room with gas then striking a match. WOOOSh Have it checked . In a forced hot water system make sure that all the registers or radiotor are bled of any air. What Hubby dont know could hurt or possibly kill you. Gas or any type of furnace should be checked each heating season
2007-11-15 14:07:07
·
answer #2
·
answered by Anonymous
·
0⤊
0⤋
once you look on the breaker panel, you notice an 'orangish' factor? this is perchance A 'floor Fault Circuit Interupter. it is going to trip if there is something incorrect with the water heater. greater constructive to circulate away it off and contact a plumber to look at it. Your community ironmongery shop (Lowe's and abode Depot) promises you names. The heating factors DO circulate undesirable after a era of use. they are able to get replaced, yet can each each now and then be not common to do. you apart from mght might desire to evaluate the age of the water heater. Is it previous, rusty, dented, or in undesirable looking situation in maximum situations? Get a sparkling one. New water heaters are plenty greater skill effective. communicate, back, to the hardware human beings. they are able to allow you already know the type and length of heater which you and your loved ones will choose. except you have youthful babies at abode (under 15 years) this is advisable to think of roughly including a timer to the heater whether this is replaced. It takes in basic terms half-hour to thoroughly warmth a tankful of water. I also have a timer on mine and run it for an hour interior the morning and an hour interior the night. The fee discounts is significant! by potential of how, a sparkling water heater could fee under $3 hundred for the heater and setting up.
2016-10-02 01:52:32
·
answer #3
·
answered by saccardi 4
·
0⤊
0⤋
You should contact a local home inspector. They can check it out and tell you honestly if there is anything wrong (it shouldn;t be really loud). If you call a plumbing contractor out, they will likely tell you that you need a new unit, because that is how they make money. A home inspector doesn't care if you fix it or not, he will just tell you what is wrong with out bias.
2007-11-15 13:45:32
·
answer #4
·
answered by Brad K 4
·
0⤊
0⤋
no real maintenance really needed except if there is other problems such as thermo-couple, circulation pump or if the chimney needs cleaning
2007-11-15 13:46:25
·
answer #5
·
answered by Herman 4
·
0⤊
0⤋