Did a firmware through linksys.com. I can't connect the router now. Did call linksys for teck support and manage to work, they also said that if I want to change my passward, I can go through the cd setup and should be fine. I went through the cd setup and router didn't work again! Don't want to call teck support again. Is it possable that the router is currupted and need a new router?
2007-11-10 01:04:34 · 2 answers · asked by Rommie 7 in Computers & Internet ➔ Computer Networking
I thought I needed the firmware. Did try resetting the router. I still can't get connected to the router.
2007-11-10 01:31:43 · update #1
a side note - the official firmware release from Linksys is quite limited in its capability/functions.
Check out http://en.wikipedia.org/wiki/WRT54G for a background info on the open-source firmware available.
I've used the open-sourced firmware, and it works much better than the official firmware. Does not hang/jam (the memory buffer) when there're heavy downloads.
2007-11-10 02:07:01 · answer #1 · answered by Jason K 2 · 1⤊ 0⤋
reset your router
look for a very small hole or button push and hold down for about 10 seconds
now try and connect
are you sure youi needed the firmware update ?
to change your username and password
log on to the router by inputting the IP address into your browser address bar.
2007-11-10 01:09:06 · answer #2 · answered by whatanidname 5 · 0⤊ 0⤋