since the surface of the intake manifold is flat where the hairline crack is i had an idea. (drill the ends of the crack so that the crack doesn't spread. Then take 2 screws through washers, through a fashioned metal plate, through a somewhat matching o ring and some silicone, and into the intake manifold). Does anyone think this will work? if not do you have any ideas. I don't really have the money to buy a new intake because of school.
2007-11-05 20:41:33 · 6 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
Not worth trying to patch. You can buy a replacement manifold at most auto parts stores for less than $150. If you are reasonably mechanically inclined, you can change it yourself in about 2-3 hours. If not, you can take it to a shop and have it done for less than $300 if you buy the manifold. A footnote to this-- Ford vehicles in that era are well known for this problem. The replacement manifolds have a few design improvements to prevent future failures. Good luck and I hope this helps!!
2007-11-05 20:47:05 · answer #1 · answered by kuntryguyy 4 · 0⤊ 0⤋
All patches are like temporary band aids. Don't drill the crack! More damage. Some Jb weld should be a effective temporary fix. about $8
2007-11-05 20:58:32 · answer #2 · answered by ? 2 · 0⤊ 0⤋
Clean the surface up real good,rough it up with some 80 grit sandpaper and clean it again,then get yourself some JB Weld fallow the instructions and apply it to the crack
2007-11-05 20:47:58 · answer #3 · answered by jasonbatla 4 · 0⤊ 0⤋
See if your vic falls under a factory recall.
My 96 had the same problem and the dealership replaced it
at no cost.
2007-11-05 21:38:21 · answer #4 · answered by PENMAN 5 · 1⤊ 0⤋
Talk to a dealer first you may be surprised ~~
2007-11-05 21:46:03 · answer #5 · answered by burning brightly 7 · 0⤊ 0⤋
JB WELD
2007-11-05 23:34:18 · answer #6 · answered by pjwilkinson2006 2 · 0⤊ 1⤋