I was using my PC when suddenly it hanged me. I waited for few minutes but seems nothing happens. So i pressed RESET...but my nothing appears on my monitor. No beep sound. Fan is working and i only see yellow grren light blinking (monitor). I cleaned the Video card as well as the memory card but it didnt help. Please help what am i going to do? Thank you!!! ^_~
2007-11-05 17:08:42 · 16 answers · asked by janiztf 2 in Computers & Internet ➔ Hardware ➔ Monitors
OH NOOO!
No beep is NOT good!
I suspect that your monitor is not the problem.
I hate to tell you that your mother board or power supply may be gone! (PRAY to the computer gods that it is your power supply!)
Take your monitor to another computer, like any friend that has a computer. Plug it in (to the computer and power) and turn it on. I will bet you Dollars to Euros that the monitor works.
Sound like you have the "No Beep Blues" which usually means Mother Board or Processor problems.
Heat, humidity, static electricity, dust, lightening, and any number of other conditions can kill a MoBo (MotherBoard).
I hope I am wrong, but I would bet that I'm right.
Good Luck!
I hope this helps!
2007-11-05 17:23:06 · answer #1 · answered by troydowning 5 · 0⤊ 0⤋
Check that the brightness is not on 0.. these things happen sometimes!
You say that everything is plugged in, but have you checked that the cable between your PC and your monitor is sitting securely? If it has come loose or if the cable is faulty then that may be the cause of your problems.
Could be a dead video card , try a new one
2007-11-06 01:18:57 · answer #2 · answered by Godzilla Gal 4 · 0⤊ 0⤋
the monitor turns on when it senses a horizontal pulse from the computer to sync it in. the video card is most likely bad, but then again I seen alot of bad cables from monitor to computer, inspect the 15 pins to see if all straight , one might be completely bent over, if doogle just tighten the screws some more and make sure both sides are tight,
cats love tearing up these cables.
2007-11-06 01:16:08 · answer #3 · answered by Anonymous · 0⤊ 0⤋
ohh. i think i know. try to find where the monitor is connected to the computer. have your computer on and take the cord out of the computer( you'll probably have to screw it off). then, after taking it out put it back in and it should do something, like a click or somethin. if that doesn't work turn you comp off, with the monitor cord out of it, and turn it on then put the cord in. i have to do it every once in a while for unknown reasons. soooo? how do you ask this question if you comp monitor isn't working?... hmmm.... something is fishy... ha ha. j/k. you're probably on your friends of course.
2007-11-06 01:14:32 · answer #4 · answered by Anonymous · 1⤊ 0⤋
Sounds like your monitor has bit the dust!
2007-11-06 01:11:11 · answer #5 · answered by char__c is a good cooker 7 · 0⤊ 0⤋
what operating system are you running if its vista. you may need to download the patch for your system. i had to turn the monitor on and off like 5 times, try it might work
2007-11-06 01:13:31 · answer #6 · answered by karim n 1 · 0⤊ 0⤋
Does it boot if you turn it off and then back on? Mine does the same thing if I reset it, but works fine if I shut down completely.
2007-11-06 01:12:12 · answer #7 · answered by Hoose 3 · 0⤊ 0⤋
Do you hear the HD working??
Your video card could be bad...
can you see the bios bootup?
if not then it is either video card is bad or u have a bad cpu..
2007-11-06 01:12:32 · answer #8 · answered by kennilope 3 · 0⤊ 0⤋
i don't think that it is a problem of your monitor or video card rather it might be problem of your ram or hard drive. plz replace your ram and hard disk and i m aslo suggesting u to go bios setup and see.
2007-11-06 01:51:46 · answer #9 · answered by mustaque.sami 2 · 0⤊ 0⤋
Try hooking the CPU to another monitor.
2007-11-06 01:15:12 · answer #10 · answered by Jacks036 5 · 0⤊ 1⤋