i have a 87 chevy 350 i just put a crank kit in and has true dual exasut on it and it burns oil on only the driverside of the engine. no smoke comes from the passenger side exaust pipe. only the drivers side. what can cause this?
2007-11-04 16:12:55 · 8 answers · asked by Chris L 1 in Cars & Transportation ➔ Car Makes ➔ Chevrolet
Rings on the drivers side aren't seated correctly and oil is blowing by. or maybe the pistons and rings aren't correct for the bore.
2007-11-04 16:17:23 · answer #1 · answered by Tommy H 5 · 0⤊ 0⤋
nicely permit me share something with you. A 1984 350 wasnt designed for gasoline financial device. all which would be accomplished is the basics. oil variations, music united statesfilter variations ans acceptable tire rigidity. in case you dont have a cap on your truck that's recommended to the two get on or have a toneau conceal positioned on. or the undemanding answer is take away the tail gate and if hauling interior the trucks mattress you will could desire to place in a mattress internet. different than that end employing the A/C and sweat it out
2016-10-03 09:11:16 · answer #2 · answered by ? 4 · 0⤊ 0⤋
Bad valve guides, bad rings or stopped up oil return hole at the rear of the head. The stopped return hole is a no brainer to fix, just run a wire downit to clear it. Bad rings should show up on a compression check. If both of those check out then it could be bad valve guide(s).
2007-11-04 16:19:24 · answer #3 · answered by mustanger 7 · 0⤊ 1⤋
before you condemn the rings...check the intake gasket on that side. if its sucking past the gasket to the underside of the intake it could be burning on one bank only. are you getting oil soakings on 1-3-5-7? valve stem seals???
2007-11-06 01:05:22 · answer #4 · answered by chevy_man_rob 5 · 0⤊ 0⤋
The rings and or valve guides in that one side are suspect. Do a cyl leak down test on all cyl and that will narrow it down. Good luck.
2007-11-04 16:17:35 · answer #5 · answered by The Mechanic 3 · 2⤊ 0⤋
Your oil rings on the driver side are burnt out.
2007-11-04 16:17:59 · answer #6 · answered by Nikki T 2 · 0⤊ 2⤋
bad rings or bad valve stem seals will cause this too happen,also if its been ran hot that will cause it too,there's many things that can actually cause it ,you may have to tear in to it to find out for sure,good luck on it.
2007-11-04 16:17:41 · answer #7 · answered by dodge man 7 · 1⤊ 1⤋
bad rings on that side
2007-11-04 17:02:28 · answer #8 · answered by magnum4574 2 · 1⤊ 1⤋