Need help attaching gate to house?

Question

I am trying to attach a wooden gate to my garage. I can't bury a post because there is a concrete sidewalk there and don't want to have to bust into it. I have old cedar lap siding so finding a flat wall is also an issue. There is a stud behind the lap siding however where I want to put the gate.

The hinge side will be attached to the garage, with the gate spanning a sidewlk and latching onto a post in the ground. The fence will continue another 4 feet to the house.

Answer 1

Bruce offers some good clues. I'll just add my two cents. One question I have is...Is the STUD accessable? If not, make it so and patch after. Add a double stud and support both with plates into the stud where it attaches at the footer and header. Add additional horizontal supports as well if able. Is this at the leading corner of the house?

Then; as was suggested use shims and your support post. 2 x 4; etc. I'd not use LAGS. I'd use Long enough bolts to go all the way through all the support structure/ fender washers/ and nuts. 3/8 galvanized at an appropriate length should suffice.

Another question I have however, which might be as valid, is What is opposite the hinge area of the gate at the house wall? Assuming you're HANGING off the house wall. Fence? Block wall? A large tree? Just curious. Depending on that answer; I might advice completely differently.

Steven Wolf

Answer 2

1

Answer 3

You're better off not attaching to the house itself. Penetrating the walls from the outside is just a bad idea. If you're worried about sagging it sounds like you need to do some welding instead. Weld up a nice frame, or at least an under the gate base that will allow you to attach the left post to the right. You can bury the bottom part.

Answer 4

Attach the bottom of the post to the sidewalk with a cast post holder made exactly for your type of application. Then simply attach the center and near the top with galvanized 5/16 or 3/8 lag bolt and flat washers. Don't worry about it pulling out of the house. Just be sure it is long enough to penetrate into the sheathing behind the siding.

Answer 5

Use a metal post plate to attach to sidewalk. You can place the fence post in it and use an 'L' bracket at the top to hold it there. You might even use a couple of other 'L' brackets in between the top and bottom to help support it You don't have to worry about uneven siding....just make sure the post is plumb.

Answer 6

In the event that you need to discover pleasant thoughts for woodworking I can propose you to check here http://woodworking.toptips.org

It's perfect in the event that you are simply starting out or in case you're a prepared carpenter.
It has thousands and thousands of woodworking arrangements and you have a CAD/DWG software to view and alter the arrangements. You have regulated instructions with photographs and excellent blueprints and schematics. On the off chance that you are a beginner this is the simplest approach to start your woodworking projects, and on the off chance that you already have experience you can at any rate discover a ton of interesting thoughts!

Answer 7

attaching gate house

Answer 8

Place and plumb your post against the siding where you want it to go.

Place wood shims (cut to size and shape) between post and siding.

Drill for and install lagbolts through post, shims and siding into stud.

Countersink bolts and washers, heads will not interfere with gate.

Two bolts will work but three is better

Answer 9

If you are planning to start on your woodworking project, this isn't something you should use, it's something that you would be insane not to. Go here https://tr.im/QKZXI
Truth is, I've been a carpenter for almost 36 years, and I haven't found anything like this for less than 10's of thousands of dollars.