my question: do I need to scrape off the linolium before I put down the cement board or can I put the cement board(hardybacker) on top of the linolium?
2007-10-25 15:41:02 · 6 answers · asked by sd4brad 1 in Home & Garden ➔ Do It Yourself (DIY)
Both answer one and two are OK, though I prefer concrete backer board. The issue with Hardi will be the same in that you'll have to skim something on either.
After installing multiple thousands of sq. ft. of tile I never have a problem with the BACKER board (by any trade name).
Your issue however might relate more to raising the floor level by 1/2 plus 1/4 plus 1/4 in board/ mortar/ and tile. I assume you'll remove cove base moldings; make cuts for any door moldings for the install?
Personally I'd probably remove the lino; but that's just me. Tile works very well on PLY. The issue with removal of course; is the adhesive used.
Steven Wolf
2007-10-25 16:13:14 · answer #1 · answered by DIY Doc 7 · 1⤊ 0⤋
I agree with the first answer in that you can place the Hardibacker right on top of the existing flooring. In fact it is advisable due to the risk of Asbestos that may have been used in the laying of the sheet flooring, depending how old the floor is. The following article recommends having the floor tested before doing any removal, .http://design.hgtv.com/kitchen/Article_detail.aspx?id=251
Secondly, you still need to ensure that you fill the seams with mortar then use 2" fiber tape before laying your tiles. This is according to the manufacturer's installation instructions.
http://www.hardie.com/developer/products_backerboard_quarterInch.shtml?openTab=jsnavLink4
I have provided expert fact and references, no I'm not a contractor, but believes that a job should be done right the first time. Short cuts may cause failure down the line, and "traditional" way's of doing things may not be as safe as they seem.
2007-10-25 21:25:48 · answer #2 · answered by fidel410 5 · 1⤊ 0⤋
the cement board is to cover up old floors and floor coverings.. and to give you a smooth level surface to lay the tile.. there should be no need to scrape the old stuff up.. just install the cement board and forget about it.. been there done that.. the cement board is great.. good luck
2007-10-25 15:50:34 · answer #3 · answered by J. W. H 5 · 1⤊ 0⤋
I agree with Doc - as usual he has nailed it. The only difference is I'm a little lazier and would probably leave the lino and put the backerboard right on top of it.
2007-10-25 16:27:57 · answer #4 · answered by Steve in NC 7 · 0⤊ 0⤋
I WOULD USE THE HARDIBACKER -- WHICH IS DIFFERENT THAN THE DURAROCK WHICH IS ACTUALLY THE CEMENT BOARD -- THE CEMENT BOARD HAS TAPERED EDGES THAT WOULD NEED TO BE TAPED WITH FIBERGLASS TAPE AND FLOATED WITH A CEMENT COMPOUND FOR PROPER INSTALLATION -- HARDIBACKER IS GREAT -- JUST USE ENOUGH SCREWS THAT ARE MADE FOR THE APPLICATION AND YOUR READY TO GO !!
2007-10-25 15:57:46 · answer #5 · answered by Anonymous · 0⤊ 1⤋
Just put the hardibacker straight down
2007-10-25 18:11:37 · answer #6 · answered by brainstorm 7 · 0⤊ 0⤋