3 ounce cannisters, Sierra gun
2007-10-22 18:47:24 · 4 answers · asked by Bruce L 1 in Cars & Transportation ➔ Boats & Boating
Load the canister into the gun, the cartridge is labeled as to what end goes in first. Once you put the gun back together release the plunger that applies pressure to the grease. Squeeze the trigger until grease comes out and then put the nozzle on the fitting and pump away until you see the grease come out of the bearing buddy. If you dont have bearing buddies get them. They keep pressure on the grease to lube the bearings. Grease often.
2007-10-23 00:46:08 · answer #1 · answered by mark t 7 · 2⤊ 0⤋
Answer #3 (mark t) correct. This not an air gun, so, lock plunger back, load grease cartridge (Usually the end with cap go toward plunger, pull off cap toward the Grease/Handle end). Put it together, unlock the plunger and lock on the fitting and pump.
The reason the pull off cap end go away from the plunger. It will have a small ridge inside and the plunger hang on this and not work.
2007-10-23 02:46:00 · answer #2 · answered by Snaglefritz 7 · 1⤊ 0⤋
Get a wet suit, air tanks and mask, back trailer into ocean and apply grease.
2007-10-22 18:57:44 · answer #3 · answered by good_fatrabbit 3 · 1⤊ 2⤋
It is better to pack the bearings by hand, messy, but better job done.
2007-10-22 19:51:58 · answer #4 · answered by dreamcatchermwhk 4 · 2⤊ 1⤋