I have a small amount of water in one of the pontoons on my pontoon boat.?

Question

How do I remove water and is this a serious problem

Answer 1

Good Afternoon,

Some will say that if you do not have a drain plug in the back of your pontoons that you should drill a hole, drain the water and install a marine brass plug in the back. That's fine if you know for a fact that it will not leak as that drain plug will be underwater, but it also will not work if you have compartments in your pontoons, that is, your pontoons are actually made of sections welded together. If they are "sectionalized," I have found the best way is to drain them from the top. Drill a hole through your deck directly into the top of your pontoons, one hole for each section. If you have flip-up seats, drill the hole in those seat compartments so that they aren't visable on the boat. Then, you can either purchase a livewell pump or basic water pump, or use a shop-vac, and suck the water out of the top. That way, you don't have to worry about leaky plugs that are underwater, and you don't have to pull the boat out of the water to drain it. Leaky pontoons aren't a serious problem if you are not beaching the boat very often, but more than likely they are leaking from the seam on the bottom of the pontoons. You can get it pressure tested, or have someone with a welder reseal the pontoon. Other than that, if it's not leaking too quickly, use your pump and continue enjoying your boat.

Answer 2

Do you have a drain plug in back at bottom of log? If not you have sealed chambers. Look on top of log under toon and look for a plug. If you have one remove plug and get a plastic tube small enough to go inside and hook to wet/dry vac. When water is gone replace plug.
Now you need to find leak. Take a spray bottle with a few drops of dish soap and start with all welds, then the seams, and then the keel or bottom of toon. You may have to pressurize logs to find leak so get help and be careful not to add more than 5lb of air pressure as it could rupture a log if more.
Good luck.

Answer 3

this is easily a SWATH hull layout. SWATH stands for Small Waterplane section twin Hull. the foremost flotation quantity is under the floor on each and each hull. this supplies for an extremely stable platform, much less plagued by using wave action. The layout is widespread for ocean examine vessels, small cruise ships, dive ships, and so forth.

Answer 4

Haul out an drain>Or drill a hole in the back insert a hose and pump out> Also there is a hole some where>