English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

My CD drive is broken. It won't open and it is making this clicking sound and it makes litte movements like it is tryiong to open but can't. How involved is installing a new drive? Thanks.

2007-09-24 16:30:57 · 6 answers · asked by ljv1975 2 in Computers & Internet Hardware Desktops

6 answers

It's not hard at all. Unplug the computer, remove the screws from the back, take the case cover off, remove the power cord and data cable from the CD drive, remove the screws from the sides of the drive, push it through the front of the computer. Open the new drive and reverse those steps.

HOWEVER, before starting, just take a paperclip and straighten it out. Poke it into the little hole on your CD drive. The door will open, and you can see what's stuck.

2007-09-24 16:34:47 · answer #1 · answered by Stuart 7 · 0 0

Very easy, Just pull case from computer, and you will notice the CD is mounted with probably 2 screws on each side. Unplug the Power and IDE connector from back, and remove CD. After getting it out match new CD to the master/slave jumper on back of CD. You can use a DVD if you like since they are identical except DVD's play movies, and CD's don't. :)

2007-09-24 16:45:38 · answer #2 · answered by Anonymous · 0 0

It's no sweat. It's just opening the case, removing some screws and replacing the drive.

Done it tons of times on our computers here at home. Just remember to unplug the computer first. You don't want the power running through the computer while you work inside it.

2007-09-24 16:35:06 · answer #3 · answered by airjarrod 7 · 0 0

extremely easy. there's only two wires you have to remove, and you can't plug them in wrong, they only go one way. (IDE and Molex)

There can sometimes be a third, this will be used for a direct connection of your cd drive to sound card. Its not really needed anymore, it was used to get music directly to your sound card from the CD so you can use the headphone jack but computers are faster today and no longer require it.

2007-09-24 16:35:12 · answer #4 · answered by skinner927 2 · 0 0

CD/DVD ROM drives are extremely uncomplicated to replace. Any IDE/ATA type (it extremely is often going on) CD/DVD Rom would desire to be utilized as a decision. you are able to p.c... them up extremely inexpensively at any interior sight laptop/electronics keep. you are able to as ideal get them at your interior sight WalMart. installation the rigidity is amazingly uncomplicated to boot, extremely on the same time as you're removing the previous one. maximum drives have 3 wires to hook them in. before removing the previous rigidity learn out the cables, and the region they're plugged in, by using actuality the nice and comfortable rigidity could be plugged indoors an same way: a million) IDE ribbon cable, a flat cable with approximately forty wires in it, and an prolonged flat connector. One edge of the cable could have a purple stripe, which shows the "first" or determination one twine. This stripe helps to instruct which way the cable is plugged in. The purple stripe is often put in closest to the flexibility connector (which I make sparkling next). 2) skill cable is a 4 twine cable with a connector that for the period of the time of elementary words suits into the rigidity one way. The purple stripe on the flag IDE cable would desire to be put in closest to this cable 3) Audio cable is an extremely small 2 or 3 twine cable that is going from the rigidity to the sound kit (many times a card) indoors the laptop. This cable in effortless words suits in one way. the rigidity itself is fastened with 4 small screws, 2 on the two components of the rigidity. On many greater desirable moderen computers drives are fastened on "rails" which enable the rigidity to slip out and in of the case truthfully without the want for suggestions. learn the rigidity and seek for for clips that could enable the rigidity to slip forward or backward from the case. If now not, then seek for for the screws. word: you are able to desire to skill down the laptop before taking off the case, and unplug the flexibility cable from the lower back of the laptop to be maintain. additionally becareful to now not lose any screws indoors the case as they'd short out the laptop on the same time as skill is restored.

2016-12-17 09:36:26 · answer #5 · answered by rosalee 4 · 0 0

Is Easy you'll be ok just search online how to install that's how i did and it works perfectly

2007-09-24 16:42:34 · answer #6 · answered by No.1 2 · 0 0

fedest.com, questions and answers