what type of grease should I use on my driveshaft spline into the yoke.?

Answer 1

High temp. synthetic grease is a winner for this application. Lucas and Red Line can be purchased at most auto parts stores.

Answer 2

On a two piece driveshaft the "slip yoke" has a grease fitting on it and you can use any grease that's in your grease gun. Same stuff you use on the ball joints and tie rods and steering linkage.

On a one piece driveshaft the slip yoke is the transmission rear splined shaft and this is never greased. The tranny fluid does the lubricating.

The slip yoke is the place where the driveshaft moves forward and backward when the rear end of a vehicle recoils from various road conditions or you add considerable weight to the vehicle.

Good Luck!

Answer 3

almost any variety of grease will do the job in this actual utility. The areas being lubed are no longer under any severe situations so maximum any grease will paintings, even the spray type white lithium grease will suffice. interior the case the place a particular grease is needed, you will discover that out the two interior the owner's handbook or by a call to a broking, areas branch.

Answer 4

White Lithium grease,or wheel berring grease.

Answer 5

i use ordinary grease but there is specil grease callwed driveshaft grease from gm

Answer 6

None. Do not introce any grease into the transmission. The transmission fluid will do all the lubricating for you.

Answer 7

standard heavy duty grease will work just fine available at your local auto parts store

Answer 8

Regular chassis grease is fine for that.

Answer 9

Any all purpose grease will do.