what do motocross racers use in 2 stroke fule?

Question

what fuel octane should i run in racing a yfs 200 blaster

can i add a can of octanboost to 2.5 gal. of gas

Answer 1

A two stroke fuel consists of one part gasoline and one part oil, both mixed in the same tanks, the ratio depends on each bike.

But dont waste your time with octane boost,
Just get VP racing fuel. as your gas and than mix it with a good 2 stoke oil. VP has a very high Octane, so you dont need to add mixxer to increase the boost.

But beware some VP cost up to $6.00 to $10.00 a gallon.
But its better for the bike so you wont get Pre-Detination it the motor

Answer 2

I would not run octane boost in a little quad like that. The pros who run 2 stroke engines have high compression top ends in thier bikes, allowing for the extra umph the higher octane gas they use offers.
The pros you see using the 2 stroke engines use 110 octane VP or TRICK racing fuel mied at 32:1 with a high quality grade 2 stroke oil...
for your Blaster, try using the highest pump grade available, usually 92 octane, mixed with 32:1 to 40:1 oil ratio.
this will give you great performance.
Try not to use octane boost, your engine will last a lot longer.

Answer 3

they get a fuel called Klotts Fuel it comes in a metal 5 gallon can allready mixed in high octane racing fuel

Answer 4

A two stroke fuel consists of one part gasoline and one part oil, both mixed in the same tanks, the ratio depends on each bike, the conditions and the weather at the time of each race.

Answer 5

regular gas and 2 cycle oil.
if your a a racer i'd use VP racing fuel.
that stuff is sooo amazing.

it comes pre mixed.

but whatever you do don't put in just gas!!
that will really screw up your bike and you'll need a new motor.

Answer 6

After market, high octane gas and a good two cycle oil.

Answer 7

mixxed