I heard some of these cars came with a rear anti sway bar? if im not mistaken the magnum(78,79) 300 and charger(77) was from that era came with this as an option can I get one from one of these cars and bolt it on? and what exactly does it bolt on too? I also have dual flowmasters running straight back over but bent over my rear axle will this get in the way of the sway bar install?
2007-09-15 17:58:42 · 4 answers · asked by hatinnicwhy 2 in Cars & Transportation ➔ Car Makes ➔ Chrysler
Get one from JC Whitney. Hellwig direct fit for many models or cars and trucks. Comes with all the hardware you need to bolt it on. Doubt you'll have to drill any holes but if you do it would only be two holes. Most frames have existing holes that the sway bar hardware bolts to.
They bolt to the axle tube(s) and to the frame in most cases. A relatively easy job. Like one hour at the most.
Good Luck!
2007-09-15 18:15:52 · answer #1 · answered by CactiJoe 7 · 0⤊ 0⤋
to be waiting to apply the cheap jc whitney kit you're able to desire to do away with the tilt burn device from the vehicle.that would require procuring and setting up a mopar overall performance digital ignition conversion kit.on an analogous time as your vehicle allready has an digital ignition it quite is a lean burn one it quite is the reason you have the computing device container on your breather.The mopar kit makes it achievable to get rid of that once which you will run a chrome air filter out kit without it.I trust chewy circulate with a mopar overall performance gown up kit it quite is a lot nicer.familiar chrome valve covers tend to leak oil aluminum ones artwork extra useful.
2016-11-15 08:42:05 · answer #2 · answered by Anonymous · 0⤊ 0⤋
http://www.p-s-t.com should have a bolt-on one that will fit.
2007-09-15 18:06:42 · answer #3 · answered by chewy 4 · 1⤊ 0⤋
VERY.............EVERYTHING IS JUST BOLT ON.
2007-09-18 09:33:46 · answer #4 · answered by Anonymous · 0⤊ 0⤋