I need change my garage door opener, is easy??, can i do by my self??. Some one with same experience?.
2007-09-14 11:07:03 · 6 answers · asked by Anonymous in Home & Garden ➔ Do It Yourself (DIY)
You got a bunch of answers but I want to add something. Installing a garage door opener is actually pretty easy as long as you are replacing one. If that is the case I am sure you can handle it, instructions are usually pretty good. If you have not had a garage door opener installed than it is a bit more work and a lot more planning. You need to find floor joists in garage ceiling, attach the tract, get the right tension etc. I would solicit some help at that point. Good Luck!
2007-09-18 10:57:28 · answer #1 · answered by Derek 4 · 0⤊ 0⤋
LOL I was just about to send and lightning knocked out my power.
Yes you can DIY this, no it is not difficult.
What makes it an easier task for you, is that one exists already. Without knowing its type, I prefer the Screw/Auger type.
The issue is that you should leave the attachment hardware in place to begin with.
The NEW opener will come partially disassembled. Remove the old motor, and drive unit; replace the motor first; then whatever type of drive unit you choose; and attach it to the motor. You may need an additional step ladder or something to prop up the drive unit at the door end.
You may be able to use OLD hardware; still in place; even if it's the same; but I'd replace it; using the positioning in existance.
On the Auger type, and perhaps on all types there should be a release lever in case the power goes out; as mine just did a few min. ago. That allows the door and drive guide to slide disengaged.
In the process, and the instructions you'll probably note some adjustment may have to be made. The process will be clearly defined in the install directions.
Obviously unplug the old unit or disconnect the wiring and shut off the breaker. I hope that didn't need to be stated.
Steven Wolf
2007-09-14 20:12:48 · answer #2 · answered by DIY Doc 7 · 0⤊ 0⤋
Most garage door openers are made so that they can be installed by the homeowner. There should be a list on the box, showing what tools you need to do the job, and an instruction list inside the box.
A second pair of hands will help too... they can be a bit bulky to lift in place and secure.
Have Fun
2007-09-14 18:27:33 · answer #3 · answered by thewrangler_sw 7 · 0⤊ 0⤋
You would make a poor garage door opener.
2007-09-14 18:15:37 · answer #4 · answered by Anonymous · 0⤊ 0⤋
Yes it can be done by your self. If your door springs are the type that have to be twisted in place be sure to be very careful if you have to mess with them.
2007-09-14 19:05:20 · answer #5 · answered by Lear B 3 · 0⤊ 0⤋
since you already have one then all you need to do is put the new one in the same place as the old.
2007-09-14 18:16:29 · answer #6 · answered by george 2 6 · 0⤊ 0⤋