2007-09-10 09:01:22 · 5 answers · asked by bettyatherton 1 in Cars & Transportation ➔ Car Makes ➔ Chrysler
This car has an engine with separate ignition coils for each cylinder. And these coils have their own plug boots. Each coil with boot fastens on top of the valve cover and the boot goes down and around the plug. Unlock the engine wire harness connector at the coil and disconnect the connector. remove the nut holding the coil to the cover, and pull the coil straight up and out of the valve cover. Now you have uncovered the plug. If you are changing the plugs, put back the same type you are replacing.
2007-09-11 05:08:25 · answer #1 · answered by Jackolantern 7 · 0⤊ 0⤋
The ECM is placed interior the left front fender in front of the left wheel purely below the headlight.this is extremely achievable which you have some moisture difficulty yet you in addition to would ought to examine if there is any form of harness difficulty close to that section pacifica are properly established for broken engine mounts and it ought to brought about to rub the appropriate harness into the physique inflicting loss of floor to distinctive circuits or pulled harness out of connectors.
2016-12-16 16:38:08 · answer #2 · answered by cavallo 4 · 0⤊ 0⤋
Hey man on the top of your motor there is a plastic cover it might have one or two bolts/ nuts that hold it on but I know for a fact that it has some rubber gromits that kinda snap down on to the top of the motor. You shouldn't have to pry on it to hard. under that cover you shouldsee the coils that are on top of the plugs.
hope this helps take care!
2007-09-10 14:03:35 · answer #3 · answered by 04SuperHawk 2 · 1⤊ 0⤋
probably under the upper intake not to easy to do
2007-09-10 09:14:53 · answer #4 · answered by will 1 · 0⤊ 1⤋
you have to remove the plenum gasket and cover to get to them
2007-09-11 09:25:35 · answer #5 · answered by chrysti's midlife crisis 6 · 0⤊ 1⤋