English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

7 answers

Lower setting takes longer (trickle charge), but is believed to give deeper charge. Higher setting is fine if you don`t have as much time.

2007-09-05 06:11:20 · answer #1 · answered by srmm 5 · 1 0

Whenever possible, it's desirable for the charging rate (amperage) to not exceed 10% of battery amperage. This reduces heat buildup and boiling out water. If your bike has a 24 amp battery, use the 2 amp setting. The 6 amp setting would be ok, but for for short periods of time only such as when you must absolutely get the bike going in a hurry. Always set the charger voltage the same as the battery.

2016-03-13 01:51:18 · answer #2 · answered by Anonymous · 0 0

The difference is the time involved in the charge cycle. The 2 amp setting will take around 24 hrs. It's know as trickle charging. The 10 amp will take a couple of hours to 4 hours to do a complete charge. Hope that answers your question. Either way will work. RDC

2007-09-05 06:17:06 · answer #3 · answered by Anonymous · 0 0

Depends on when you need the battery. But some recommend that you start on 10 to jolt any oxide on the plates then finish at 2 to get a good charge that is easy on your battery, i.e. less heat.

2007-09-05 06:10:54 · answer #4 · answered by gary o 7 · 1 0

It depends on the charger. On a fully automatic charger, 10A will be fine. If it's a cheap charger, it will cook the battery dry if you leave it on 10A too long.

2007-09-05 09:58:50 · answer #5 · answered by Nomadd 7 · 0 0

10 Amps for 5 hours or 2 Amps for an overnight charge.

2007-09-05 06:10:01 · answer #6 · answered by bobweb 7 · 1 0

2a Battery

2016-10-15 06:02:23 · answer #7 · answered by Anonymous · 0 0

fedest.com, questions and answers